ATAVRFBKIT Atmel, ATAVRFBKIT Datasheet - Page 25

• Manufacturer Part Number: ATAVRFBKIT
• Description: KIT DEMO BALLAST FOR AT90PWM2
• Manufacturer: Atmel
• Series: AVR®r

Specifications of ATAVRFBKIT

• Main Purpose: Lighting, Ballast Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: AT90PWM2, AT90PWM3
• Primary Attributes: 18 W, Up to 2 Type T8 Lamps, Dimmable, Auto Detect of Swiss or DALI
• Secondary Attributes: Power Factor Corrected (PFC), 90 to 265 VAC, 90 to 370 VDC
• Data Bus Width: 8 bit
• Core Chip: AT90PWM2B
• Topology: Boost
• No. Of Outputs: 1
• Dimming Control Type: Digital
• Kit Contents: Board CD Docs
• Development Tool Type: Hardware / Software - Eval/Demo Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7597B–AVR–10/07
ATPWMX Demonstrator Software
6-23
CONFIGURE_LAMP_PREHEAT
This is the first time the lamp is attempted to be started once the user has requested to
switch it on.
Configure the amplifier0, which is used to measure the current, then configure the PSC2
according to the definitions in the config.h file, and initialize all the lamp control
variables.
Then jump to the LAMP_PREHEAT state.
LAMP_PREHEAT
Starts the preheat sequence for LAMP_PREHEAT_TIME. (PWM set up at 80KHz)
Then jump to the START_IGNITION state.
START_IGNITION
Decrease the frequency from the init frequency down to INVERTER_IGNITION_HALF_
PERIOD.
Then jump to the IGNITION state.
IGNITION
The ignition sequence consists of maintaining the ignition frequency determined by
INVERTER_IGNITION_HALF_PERIOD for 10ms, and then checking if ignition occurs
by measuring lamp current and voltage.
In case it has... START_RUN_MODE.
In case it hasn’t... RESTART_PREHEAT.
RESTART_PREHEAT
Reconfigure the Inverter with the Restart parameters, then go to LAMP_PREHEAT.
If Ignition fails too many times... Go to TOO_MANY_LAMP_IGNITION_TRIES.
START_RUN_MODE
Increase the frequency from the init frequency, INVERTER_IGNITION_HALF_PERIOD.
Then jump to the RUN_MODE state.
RUN_MODE
Normal control loop to have the light in accordance with the
variable that is permanently updated in the command control state machine in the
Main_pwmx_fluo_demo.c file.
The transition from the RUN_MODE state to the LAMP_OFF state is done in the control
state machine (control_FBKIT.c file) when the
0.
gv_lamp_preset_current
ATAVRFBKIT / EVLB001 User Guide
gv_lamp_preset_current
variable is set to