EVAL6206N STMicroelectronics, EVAL6206N Datasheet - Page 12

• Manufacturer Part Number: EVAL6206N
• Description: EVAL BOARD FOR L6206N DIP
• Manufacturer: STMicroelectronics

Specifications of EVAL6206N

• Mfg Application Notes: PractiSPIN AppNote
• Design Resources: EVAL6206N/6206N Gerber Files EVAL6206N Schematic/Bill of Materials
• Main Purpose: Power Management, H Bridge Driver (Internal FET)
• Embedded: No
• Utilized Ic / Part: L6205N DIP
• Primary Attributes: Dual Full-Bridge (H-Bridge), 2.8A (5.6A Peak). 8 ~ 52 V, 0.3 Ohm
• Secondary Attributes: Non-Inverting, Can be Paralleled
• Architecture: Analog
• Applications: Motor Control
• Processor To Be Evaluated: L6206
• For Use With: 497-4138 - EVALUATION BOARD PRACTISPIN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-5487

Microcontroller
3
3.1
3.2
3.3
12/39
Microcontroller
Microcontroller features
The board is based on the ST72F651AR6 USB microcontroller, its mains features are:
●
●
●
●
●
This microcontroller embeds several on-chip peripherals:
●
●
●
●
●
●
●
●
RS-232 Interface
The RS-232 interface is emulated by software using:
●
●
●
The firmware implements a half-duplex RS-232 interface, whenever a simultaneous
reading/writing operation occurs the writing operation is aborted and the reading operation
is performed without loss of data.
Internal time base generation
An internal 1ms time base is generated using one output compare resource and a free
counter. The free counter is then used to generate up to 10 programmable timeout counters
(with 1ms resolution).
Up to 8MHz ST7 control unit
32 KBytes embedded Flash program memory
5 KBytes embedded RAM memory
UVLO
Up to 47 general purpose IOs with 3 Interrupt sources, two separated IO banks (one
supplied at 5V and one between 2.7V and 5V).
Programmable watchdog timer/counter
Programmable DMA controller (DTC) with 256 bytes dedicated memory
Full-speed USB controller with 5 endpoints and a 1280 bytes dedicated memory for
buffers
One 16-bit timer with 2 Output Compare units
A 10-bit PWM generator with 2 channels
A full-duplex SPI peripheral (master / slave)
I²C bus interface (single master)
8-channels, 8-bit A/D Converter
One general purpose IO () as TxD signal
One Interrupt source IO () as RxD signal.
One Output compare unit to generate the correct timing for transmission and reception.
UM0240