EVAL6206N STMicroelectronics, EVAL6206N Datasheet - Page 19

• Manufacturer Part Number: EVAL6206N
• Description: EVAL BOARD FOR L6206N DIP
• Manufacturer: STMicroelectronics

Specifications of EVAL6206N

• Mfg Application Notes: PractiSPIN AppNote
• Design Resources: EVAL6206N/6206N Gerber Files EVAL6206N Schematic/Bill of Materials
• Main Purpose: Power Management, H Bridge Driver (Internal FET)
• Embedded: No
• Utilized Ic / Part: L6205N DIP
• Primary Attributes: Dual Full-Bridge (H-Bridge), 2.8A (5.6A Peak). 8 ~ 52 V, 0.3 Ohm
• Secondary Attributes: Non-Inverting, Can be Paralleled
• Architecture: Analog
• Applications: Motor Control
• Processor To Be Evaluated: L6206
• For Use With: 497-4138 - EVALUATION BOARD PRACTISPIN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-5487

UM0240
6.5
6.6
6.7
Table 5.
The two PLC interface control signals are connected in the PLM board either to the GND or
to V
possible configurations but only two are, at present, in use:
●
●
Table 6.
In-circuit communication
The In Circuit Communication connector provides access to several debug features and to
the In Circuit Programming function that enables complete writing to the MCU Flash
memory.
Power supply
As described in
is power supply from different sources. If an external dedicated power supply is selected, it
must be in the 5V ÷ 35V range.
Taking into account that the board has a power consumption in steady state of
approximately 50mW, a value of 500mW is suggested.
The external power supply connector is a standard 2.5-mm phone jack that is compatible
with common PC notebook power supply connectors.
Jumpers
Five jumpers are present on the board to give flexibility on the use of reset management,
DAC reference voltage; In Circuit Communication and RS232 interface power supply.
Pin number
DD
00 (GND,GND) for the ST7538
10 (GND,V
Pin number
and are used to detect which modem is mounted on the board. There are four
20
28
22,34
2
4
6
PLC interface control signals
Power connections
DD
Section 2: Power
) for the ST7540
Signal name
B_ID_PLM_1
B_ID_PLM_0
Signal name
PLM_10V
VDDF
GND
VDD
supply, the ST Industrial Communication Board can take
Board ID for PLM Applications (MSB)
Board ID for PLM Applications (LSB)
10V power supply
3.3V/5V power supply
Digital power supply
Ground
Description
Description
Interfaces and connectors
Generated by
Generated by
Modem
Modem
Modem
Ground
Modem
Modem
19/39