LM8322EVALKIT National Semiconductor, LM8322EVALKIT Datasheet - Page 17

• Manufacturer Part Number: LM8322EVALKIT
• Description: BOARD EVALUATION LM8322
• Manufacturer: National Semiconductor

Specifications of LM8322EVALKIT

• Main Purpose: Interface, Special Purpose
• Embedded: No
• Utilized Ic / Part: LM8322
• Primary Attributes: Mobile I/O Companion with Key-Scan, I/O Expansion, PWM, Access.bus Host
• Secondary Attributes: Board has MCU for USB to PC GUI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

keyboard matrix. The default GPIO configuration is an input
with the pullup disabled.
13.1 USING THE CONFIG_X PINS FOR GPIO
The CONFIG_1 and CONFIG_2 pins are available for use as
GPIO pins after power-on or reset. However, stable states
must be provided on these pins during power-on or reset to
select the ACCESS.bus (I
External pullup or pulldown resistors can be used to pull either
CONFIG_x pin low, while retaining the ability to drive it to an-
other state when used as a GPIO pin.
CONFIG_2 has two alternate functions, in addition to GPIO.
It can be configured as a multiplexer output using the
2
C) bus address.
FIGURE 11. GPIO Port State Change Timing
17
WRITE_CFG command (0x81), in which case it will not be
available as a GPIO pin. It can also be configured as a PWM
output, which also would override its use as a GPIO pin.
13.2 GPIO TIMING
When a WRITE_PORT_STATE command (0x86) is received,
the GPIO outputs do not change to their new states immedi-
ately or simultaneously. The first one changes 54 µs after the
command is acknowledged, and the others change at inter-
vals of 7.3 µs, as shown in Figure 11.
30013611
www.national.com