DS26334DK Maxim Integrated Products, DS26334DK Datasheet - Page 31

• Manufacturer Part Number: DS26334DK
• Description: KIT DESIGN FOR DS26334
• Manufacturer: Maxim Integrated Products

Specifications of DS26334DK

• Main Purpose: Telecom, Line Interface Units (LIUs)
• Utilized Ic / Part: DS26334
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

5.6 Jitter Attenuator
The DS26334 contains an on-board jitter attenuator that can be set to a depth of either 32 or 128 bits via the JADS
bit in register
The 128-bit mode is used in applications where large excursions of wander are expected. The 32-bit mode is used
in delay sensitive applications. The characteristics of the attenuation are shown in
can be placed in either the receive path or the transmit path or none by appropriately setting the JAPS and the JAE
bits in register GC. These selections can be changed on an individual LIU basis by settings in the
In order for the jitter attenuator to operate properly, a 2.048MHz clock or multiple thereof, or 1.544MHz clock or
multiple thereof, must be applied at MCLK. ITU-T specification G.703 requires an accuracy of ±50ppm for both T1
and E1 applications. AT&T Pub 62411 and ANSI specs require an accuracy of ±32ppm for T1 interfaces. On-board
circuitry adjusts either the recovered clock from the clock/data recovery block or the clock applied at the TCLK pin
to create a smooth jitter-free clock, which is used to clock data out of the jitter attenuator FIFO. It is acceptable to
provide a jittery clock at the TCLK pin if the jitter attenuator is placed on the transmit side. If the incoming jitter
exceeds either 120UI
internal nominal 32.768MHz (E1) or 24.704MHz (T1) clock by either 15 or 17 instead of the normal 16 to keep the
buffer from overflowing. When the device divides by either 15 or 17, it also sets the jitter attenuator limit trip
(IJAFLT) bits in the
Figure 5-9. Jitter Attenuation
GC.
It can also be controlled on an individual LIU basis by settings in the
IJAFLT
-20dB
-40dB
-60dB
P-P
0dB
(buffer depth is 128 bits) or 28UI
register described.
1
10
DS26334 3.3V, 16-Channel, E1/T1/J1 Short/Long-Haul Line Interface Unit
E1
Prohibited
TBR12
Area
T1
31 of 121
100
FREQUENCY (Hz)
P-P
(buffer depth is 32 bits), the DS26334 will divide the
1K
Prohibited Area
ITU G.7XX
TR 62411 (Dec. 90)
Prohibited Area
10K
Figure
IJAFDS
5-9. The jitter attenuator
100K
register.
IJAPS
and IJAE.