STEVAL-ILL024V1 STMicroelectronics, STEVAL-ILL024V1 Datasheet - Page 17

• Manufacturer Part Number: STEVAL-ILL024V1
• Description: LED BOARD FOR STM32 STP16DP05
• Manufacturer: STMicroelectronics

Specifications of STEVAL-ILL024V1

• Design Resources: STEVAL-ILL024V1 BOM STEVAL-ILL024V1 Schematic
• Current - Output / Channel: 100mA
• Outputs And Type: 16, Non-Isolated
• Voltage - Output: 20V
• Features: Short-Circuit Protection
• Voltage - Input: 3 ~ 5.5V
• Utilized Ic / Part: STM32F103VB, STP16DP05
• Description/function: LED Display Demo System Control Unit
• Product: Display Modules
• For Use With: 497-9087 - LED MATRIX DISPLAY PANEL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STM32F103VB
• Other names: 497-9091

UM0767
If the mode entered is other than 1-9 then the default mode is selected and this message is
seen on the terminal: “Default Mode: Right To Left”
●
●
●
●
●
Figure 9.
As soon as the mode is entered, the selected mode is seen on the HyperTerminal and
the next message is “Enter Speed; Entr between 1-9”. This speed is to see the display
on the LED matrix. Speed 1 is fastest and 9 is slowest. If the speed entered is other
than 1-9 then the default speed of 2 is selected.
The next message is “Enter String”.
Enter the string (the maximum allowed string length is 200 letters). When the required
string is entered, select the Enter key on the keyboard.
Data is sent to the LED matrix display and can be seen there.
The next message on the HyperTerminal is “Enter Y to re-enter display mode settings
or any other key to exit PC-UART mode:” Therefore if Y is entered, the HyperTerminal
again shows a message asking for the slave address. If any other key is entered then
the system exits PC-UART mode and the normal menu is seen on the master control
unit LCD.
ASCII settings of the HyperTerminal in the computer
Doc ID 16147 Rev 1
System operation modes
17/30