STEVAL-MKI031V1 STMicroelectronics, STEVAL-MKI031V1 Datasheet - Page 25

• Manufacturer Part Number: STEVAL-MKI031V1
• Description: PLATFORM MUSA
• Manufacturer: STMicroelectronics

Specifications of STEVAL-MKI031V1

• Sensor Type: *
• Sensing Range: *
• Interface: *
• Sensitivity: *
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: *
• Voltage - Supply: *
• Sensing Axis: Double Axis
• Output Type: Digital
• Interface Type: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LPR5xxxAL, LPY5xxxAL, LY5xxxAL
• Other names: 497-10672

LIS331DLH
7
7.1
7.2
Register description
The device contains a set of registers which are used to control its behavior and to retrieve
acceleration data. The registers address, made of 7 bits, is used to identify them and to
write the data through serial interface.
WHO_AM_I (0Fh)
Table 16.
Device identification register.
This register contains the device identifier that for LIS331DLH is set to 32h.
CTRL_REG1 (20h)
Table 17.
Table 18.
PM bits allow to select between power-down and two operating active modes. The device is
in power-down mode when PD bits are set to “000” (default value after boot).
shows all the possible power mode configurations and respective output data rates. Output
data in the low-power modes are computed with low-pass filter cut-off frequency defined by
DR1, DR0 bits.
DR bits, in the normal-mode operation, select the data rate at which acceleration samples
are produced. In low-power mode they define the output data resolution.
the possible configuration for DR1 and DR0 bits.
PM2 - PM0
DR1, DR0
Zen
Yen
Xen
PM2
0
WHO_AM_I register
CTRL_REG1 register
CTRL_REG1 description
PM1
Power mode selection. Default value: 000
(000: Power-down; Others: refer to
Data rate selection. Default value: 00
(00:50 Hz; Others: refer to
Z axis enable. Default value: 1
(0: Z axis disabled; 1: Z axis enabled)
Y axis enable. Default value: 1
(0: Y axis disabled; 1: Y axis enabled)
X axis enable. Default value: 1
(0: X axis disabled; 1: X axis enabled)
0
PM0
1
Doc ID 15094 Rev 3
DR1
1
Table
20)
Table
DR0
0
19)
Zen
0
Register description
Table 20
Yen
1
Table 19
shows all
Xen
0
25/38