STEVAL-MKI031V1 STMicroelectronics, STEVAL-MKI031V1 Datasheet - Page 29

• Manufacturer Part Number: STEVAL-MKI031V1
• Description: PLATFORM MUSA
• Manufacturer: STMicroelectronics

Specifications of STEVAL-MKI031V1

• Sensor Type: *
• Sensing Range: *
• Interface: *
• Sensitivity: *
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: *
• Voltage - Supply: *
• Sensing Axis: Double Axis
• Output Type: Digital
• Interface Type: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LPR5xxxAL, LPY5xxxAL, LY5xxxAL
• Other names: 497-10672

LIS331DLH
7.6
Table 29.
BDU bit is used to inhibit output registers update between the reading of upper and lower
register parts. In default mode (BDU = ‘0’) the lower and upper register parts are updated
continuously. If it is not sure to read faster than output data rate, it is recommended to set
BDU bit to ‘1’. In this way, after the reading of the lower (upper) register part, the content of
that output registers is not updated until the upper (lower) part is read too.
This feature avoids reading LSB and MSB related to different samples.
CTRL_REG5 (24h)
Table 30.
Table 31.
TurnOn bits are used for turning on the sleep to wake function.
Table 32.
Setting TurnOn[1:0] bits to 11 the “sleep to wake” function is enabled. When an interrupt
event occurs the device is turned to normal mode increasing the ODR to the value defined in
CTRL_REG1. Although the device is in normal mode, CTRL_REG1 content is not
automatically changed to “normal mode” configuration.
FS1, FS0
STsign
ST
SIM
TurnOn1,
TurnOn0
TurnOn1
0
0
1
CTRL_REG4 description (continued)
CTRL_REG5 register
CTRL_REG5 description
Sleep to wake configuration
Full-scale selection. Default value: 00.
(00: ±2 g; 01: ±4 g; 11: ±8 g)
Self-test sign. Default value: 00.
(0: self-test plus; 1 self-test minus)
Self-test enable. Default value: 0.
(0: self-test disabled; 1: self-test enabled)
SPI serial interface mode selection. Default value: 0.
(0: 4-wire interface; 1: 3-wire interface)
Turn-on mode selection for sleep to wake function. Default value: 00.
0
TurnOn0
0
1
0
Doc ID 15094 Rev 3
Turned on: The device is in low power mode (ODR is defined in
0
Sleep to wake function is disabled
Sleep to wake status
0
CTRL_REG1)
0
Register description
TurnOn1
TurnOn0
29/38