DC-ME-9210-NET Digi International, DC-ME-9210-NET Datasheet - Page 54

• Manufacturer Part Number: DC-ME-9210-NET
• Description: KIT JUMP START ME 9210 NET+OS 7
• Manufacturer: Digi International
• Series: Digi Connect ME®r
• Type: MCU Moduler

Specifications of DC-ME-9210-NET

• Contents: Board, Cables, CD, Digi JTAG Link Hardware Debugger, Documentation, Module, Power Supply
• Data Rate: 10 Mbps to 100 Mbps
• Memory Type: SDRAM
• Interface Type: RS-232, Ethernet
• Operating Voltage: 12 V
• Operating Current: 346 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 80 C
• Board Size: 36.7 mm x 19.05 mm
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• Silicon Manufacturer: Digi Intl
• Kit Application Type: Communication & Networking
• Application Sub Type: Embedded
• Silicon Family Name: Digi Connect ME
• Rohs Compliant: Yes
• For Use With/related Products: Digi Connect ME 9210 Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1136

RF Exposure Statement
Safety Statements
The Digi Connect Wi-ME module complies with the RF exposure limits for humans as
called out in RSS-102. It is exempt from RF evaluation based on its operating frequency of
2.4 GHz, and effective radiated power less than the 3 watt requirement for a mobile device
(>20 cm separation) operating at 2.4 GHz.
To avoid contact with electrical current:














Never install electrical wiring during an electrical storm.
Never install an ethernet connection in wet locations unless that connector is
specifically designed for wet locations.
Use caution when installing or modifying ethernet lines.
Use a screwdriver and other tools with insulated handles.
You and those around you should wear safety glasses or goggles.
Do not place ethernet wiring or connections in any conduit, outlet or junction
box containing electrical wiring.
Installation of inside wire may bring you close to electrical wire, conduit,
terminals and other electrical facilities. Extreme caution must be used to avoid
electrical shock from such facilities. You must avoid contact with all such
facilities.
Ethernet wiring must be at least 6 feet from bare power wiring or lightning rods
and associated wires, and at least 6 inches from other wire (antenna wires,
doorbell wires, wires from transformers to neon signs), steam or hot water
pipes, and heating ducts.
Do not place an ethernet connection where it would allow a person to use an
ethernet device while in a bathtub, shower, swimming pool, or similar
hazardous location.
Protectors and grounding wire placed by the service provider must not be
connected to, removed, or modified by the customer.
Do not touch un-insulated ethernet wiring if lightning is likely!
Do not touch or move the antenna(s) while the unit is transmitting or receiving.
Do not hold any component containing a radio such that the antenna is very
close to or touching any exposed parts of the body, especially the face or eyes,
while transmitting.
Do not operate a portable transmitter near unshielded blasting caps or in an
explosive environment unless it is a type especially qualified for such use
      
5 4