DC-ME-9210-NET Digi International, DC-ME-9210-NET Datasheet - Page 65

• Manufacturer Part Number: DC-ME-9210-NET
• Description: KIT JUMP START ME 9210 NET+OS 7
• Manufacturer: Digi International
• Series: Digi Connect ME®r
• Type: MCU Moduler

Specifications of DC-ME-9210-NET

• Contents: Board, Cables, CD, Digi JTAG Link Hardware Debugger, Documentation, Module, Power Supply
• Data Rate: 10 Mbps to 100 Mbps
• Memory Type: SDRAM
• Interface Type: RS-232, Ethernet
• Operating Voltage: 12 V
• Operating Current: 346 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 80 C
• Board Size: 36.7 mm x 19.05 mm
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• Silicon Manufacturer: Digi Intl
• Kit Application Type: Communication & Networking
• Application Sub Type: Embedded
• Silicon Family Name: Digi Connect ME
• Rohs Compliant: Yes
• For Use With/related Products: Digi Connect ME 9210 Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1136

65
Revision E
Revision D
Revision C
Revision B
Revision 90000631_G>90000897_A
Revision G
      
Changed schematics in appendix A to reflect correct measurements.
Added a new section labeled “Thermal Specifications” to the book. This section outlines
the temperature ranges at which the devices specified can still function properly.
Updates to schematics in Chapter 2.
Added/revised Module Pin-out table in Chapter 3.
Updated GPIO tables throughout book.
Fixed page numbers to make them correspond in PDF form.
Added components to Development Board schematics. (#19 and 20)
Added Connect ME 9210 related information.
Updated schematics in development board chapter to reflect 9210 changes.
Updated the Connectors: power and device interface section to say that pins 1 and 2 on the
connector are available if using Connect ME, not available if using Connect Wi-ME.
Updated the Embedded Module Connector table in Chapter 2 similarly.
Added tolerance information for dimension drawings
Updated Hard Reset section to clarify forcing the unit into hard reset