TOOLSTICK342DC Silicon Laboratories Inc, TOOLSTICK342DC Datasheet - Page 13

• Manufacturer Part Number: TOOLSTICK342DC
• Description: DAUGHTER CARD TOOLSTCK C8051F342
• Manufacturer: Silicon Laboratories Inc
• Series: ToolStickr
• Type: MCUr

Specifications of TOOLSTICK342DC

• Contents: Board, Cable
• Processor To Be Evaluated: C8051F342
• Interface Type: USB
• Operating Supply Voltage: 2.7 V to 3.6 V
• Lead Free Status / RoHS Status: Lead free / RoHS non-compliant
• For Use With/related Products: C8051F342
• For Use With: 336-1345 - TOOLSTICK BASE ADAPTER
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1482

7. Additional Demo Example
In addition to the F342DC_FeaturesDemo example firmware, the ToolStick download package also includes a
demo project named F342DC_HIDMouse.wsp. The instructions for running this demo can be found at the top of
the source file. The project and source files for these demos can be found in the folder,
C:\SiLabs\MCU\ToolStick\F342DC\Firmware\.
8. Using the C8051F342 Daughter Card as a Development Platform
The prototyping area on the ToolStick C8051F342 Daughter Card makes it easy to interface to external hardware.
All of the digital I/O pins are available so it possible to create a complete system.
8.1. C8051F342 Pin Connections
It is important to note that if external hardware is being added, some of the existing components on the board can
interfere with the signaling. The following is a list of port pins on the C8051F342 that are connected to other
components:
8.2. C2 Pin Sharing
On the C8051F342, the debug pins, C2CK, and C2D, are shared with the pins /RST and P3.0 respectively. The
daughter card includes the resistors necessary to enable pin sharing which allow the /RST and P3.0 pins to be
used normally while simultaneously debugging the device. See "AN124: Pin Sharing Techniques for the C2
Interface" at www.silabs.com for more information regarding pin sharing.
9. Information Locations
Example source code is installed by default in the C:\SiLabs\MCU\ToolStick\F342DC\Firmware directory during
ToolStick installation.
Documentation for the ToolStick kit, including this User's Guide, can be found by default in the
C:\SiLabs\MCU\ToolStick\Documentation and C:\SiLabs\MCU\ToolStick\F342DC\Documentation directories.
The installer for the ToolStick software is available at www.silabs.com/toolstick.
P0.0, P0.1—These pins are connected directly to the ToolStick Base Adapter's GPIO pins. By default, these
GPIO pins on the Base Adapter are high-impedance pins so they will not affect any signaling. Configuring these
pins on the Base Adapter to output pin or handshaking pins could affect signaling.
P0.4, P0.5—These pins are connected directly to the ToolStick Base Adapter for UART communication.
P2.0—This pin is connected to the "S1" switch. The switch can be removed to disconnect it from the pin.
P2.2—This pin is connected to the cathode of the green LED on the daughter card. The LED or the R2 resistor
can be removed to disconnect the LED from the pin.
P2.5—This pin is connected to the output of the potentiometer. R5 (a 0 Ω resistor) can be removed to
disconnect the potentiometer from the pin.
Rev. 0.1
ToolStick-F342DC
13