DEMO9S08LC60 Freescale Semiconductor, DEMO9S08LC60 Datasheet - Page 27

• Manufacturer Part Number: DEMO9S08LC60
• Description: BOARD DEMO FOR 9S08LC60
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08LC60

• Contents: Evaluation Board
• Processor To Be Evaluated: MC9S08LC60
• Interface Type: RS-232, USB
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08LC
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08LC60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8 Troubleshooting
8.1 USB Driver Problems
If you connected the Demonstration Board to the PC before installing the SofTec
Microsystems Additional Components, the Demonstration Board’s USB driver may not have
been correctly installed on your system. Unplugging and replugging the USB cable is of no
use, since Windows has marked the device as “disabled”. As a consequence, the PC cannot
communicate with the Demonstration Board.
To restore the USB driver (provided the SofTec Microsystems Additional Components have
been installed), perform the following steps under Windows XP:
1.
2.
3.
4.
5.
6.
7.
8.2 Communication Problems between the PC and the
1.
2.
3.
Connect the Demonstration Board to the PC.
Open the Control Panel (Start > Settings > Control Panel).
Open the “System” options.
Select the “Hardware” tab.
Click the “Device Manager” button.
The “uDART In-Circuit Debugger” device will be shown with an exclamation mark next
to it. Double click on this device.
In the “General” tab, click the “Reinstall Driver” button. Follow the on-screen
instructions.
Demo Board
Make sure that both the “BKGD” and “RESET#” jumpers in the “IO2 ENA” jumper strip
are inserted.
Make sure that the “VDD ENA” jumper in the “IO1 ENA” jumper strip is installed.
Make sure that the “POWER SEL” jumper selects the appropriate power source
(typically “USB” when the board is connected to the PC).
DEMO9S08LC60 User's Manual
Page 25