C8051F350DK Silicon Laboratories Inc, C8051F350DK Datasheet - Page 6

• Manufacturer Part Number: C8051F350DK
• Description: DEV KIT FOR F350/351/352/353
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F350DK

• Contents: Evaluation Board, Power Supply, USB Cables, Adapter and Documentation
• Processor To Be Evaluated: C8051F35x
• Interface Type: USB
• Silicon Manufacturer: Silicon Labs
• Core Architecture: 8051
• Silicon Core Number: C8051F350
• Silicon Family Name: C8051F35x
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: C8051F350, 351, 352, 353
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1083

C8051F35x-DK
6.1. System Clock Sources
The C8051F350 device installed on the target board features a calibrated programmable internal oscillator which is
enabled as the system clock source on reset. After reset, the internal oscillator operates at a frequency of
3.0625 MHz (±2%) by default but may be configured by software to operate at other frequencies. Therefore, in many
applications an external oscillator is not required. However, if you wish to operate the C8051F350 device at a fre-
quency not available with the internal oscillator, an external crystal may be used. Refer to the C8051F35x data sheet
for more information on configuring the system clock source.
The target board is designed to facilitate the installation of an external crystal. Remove shorting blocks at headers
J9 and J10 and install the crystal at the pads marked Y1. Install a 10 MΩ resistor at R9 and install capacitors at
C14 and C15 using values appropriate for the crystal you select. Refer to the C8051F35x data sheet for more infor-
mation on the use of external oscillators.
6.2. Switches and LEDs
Two switches are provided on the target board. Switch SW1 is connected to the RESET pin of the C8051F350.
Pressing SW1 puts the device into its hardware-reset state. Switch SW2 is connected to the C8051F350’s general
purpose I/O (GPIO) pin through headers. Pressing SW2 generates a logic low signal on the port pin. Remove the
shorting block from the jumper to disconnect SW2 from the port pins. The port pin signal is also routed to a pin on
the J1 I/O connector. See Table 1 for the port pins and headers corresponding to each switch.
Three LEDs are also provided on the target board. The red LED labeled PWR is used to indicate a power connec-
tion to the target board. The green LEDs labeled with port pin names are connected to the C8051F350’s GPIO pins
through headers. Remove the shorting blocks from the headers to disconnect the LEDs from the port pins. The port
pin signals are also routed to pins on the J1 I/O connector. See Table 1 for the port pins and headers correspond-
ing to each LED.
6
Green LED D2
Green LED D1
Description
Table 1. Target Board I/O Descriptions
Red LED
SW1
SW2
Rev. 0.3
Reset
PWR
P1.0
P0.6
P0.7
I/O
Jumper
J3[5–6]
J3[1–2]
J3[3–4]
none
none