MC56F8006DEMO Freescale Semiconductor, MC56F8006DEMO Datasheet - Page 4

• Manufacturer Part Number: MC56F8006DEMO
• Description: DEMO BOARD FOR MC56F8006
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8006DEMO

• Contents: Board
• Processor To Be Evaluated: MC56F8006
• Interface Type: RS-232, USB
• Operating Supply Voltage: 3.3 V
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F80xx
• Rohs Compliant: Yes
• For Use With/related Products: MC56F8006
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Chapter 1
Introduction
1.1 Cautionary Notes
1. Electrostatic Discharge (ESD) prevention measures should be applied whenever handling this
2. Axiom Manufacturing reserves the right to make changes without further notice to any
3. EMC information on the 56F8006DEMO board:
1.2 Terminology
This development board applies option selection jumpers. Terminology for application of the
option jumpers is as follows:
• Jumper on, in or installed = jumper is a plastic shunt that fits across two pins and the shunt is
• Jumper off, out or idle = jumper or shunt is installed so that only one pin holds the shunt, no
This development board applies cutaway option selections. These option selections apply
surface mount resistor locations with a printed circuit board trace connecting both component
pads. This type of connection places an equivalent 0 Ω type resistor in series with the I/O signal
and the user component or I/O connector on the board. These connections may be cut with a
razor blade or similar type knife between the component pads to isolate the default connection
provided. Reconnection of the cutaway type pads can be made by either installing a 0 Ω 0805
size surface mount resistor or a small wire jumper on the component pads.
4
product. ESD damage is not a warranty repair item.
products to improve reliability, function or design. Axiom Manufacturing does not assume any
liability arising out of the application or use of any product or circuit described herein, neither
does it convey any license under patent rights or the rights of others.
a. This product as shipped from the factory with associated power supplies and cables, has
b. This product is designed and intended for use as a development platform for hardware or
c. In a domestic environment this product may cause radio interference in which case the user
d. Attaching additional wiring to this product or modifying the product’s operation from the
installed so that the two pins are connected with the shunt.
two pins are connected, or jumper is removed. It is recommended that the jumpers be idled by
installing on one pin so they will not be lost.
been tested and meets with requirements of CE and the FCC as a CLASS A product.
software in an educational or professional laboratory.
may be required to take adequate prevention measures.
factory default as shipped may affect its performance and also cause interference with
other apparatus in the immediate vicinity. If such interference is detected, suitable mitigating
measures should be taken.
www.freescale.com