M52210DEMO Freescale Semiconductor, M52210DEMO Datasheet - Page 4

• Manufacturer Part Number: M52210DEMO
• Description: BOARD DEV MCF5221X LOW COST
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: MCUr

Specifications of M52210DEMO

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MCF52210
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet, USB
• Architecture: 32-bit (not ARM)
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire
• Core Sub-architecture: Coldfire V2
• Silicon Core Number: MCF52
• Silicon Family Name: MCF5221x
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: MCF5221x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

CAUTIONARY NOTES
1) Electrostatic Discharge (ESD) prevention measures should be used when handling this
2) Axiom Manufacturing does not assume any liability arising out of the application or use of
3) EMC Information on the M52210DEMO board:
TERMINOLOGY
This development board uses option selection jumpers. A jumper is a plastic shunt that con-
nects 2 terminals electrically. Terminology for application of the option jumpers is as follows:
Jumper on, in, or installed - jumper is installed such that 2 pins are connected together.
Jumper off, out, or idle - jumper is installed on 1 pin only. It is recommended that jumpers be
idled by installing on 1 pin so they will not be lost.
Cut-Trace – a circuit trace connection between component pads. The circuit trace may be cut
using a knife to break the default connection. To reconnect the circuit, simply install a suitably
sized 0-ohm resistor or attach a wire across the pads.
Signal names in this document that are followed by an asterisk (*) denotes active-low signals.
product. ESD damage is not a warranty repair item.
any product or circuit described herein; neither does it convey any license under patent
rights or the rights of others.
a) This product, as shipped from the factory with associated power supplies and cables,
b) This product is designed and intended for use as a development platform for hardware
c) In a domestic environment, this product may cause radio interference in which case the
d) Attaching additional wiring to this product or modifying the product operation from the
has been verified to meet with FCC requirements as a CLASS B product.
or software in an educational or professional laboratory.
user may be required to take adequate prevention measures.
factory default as shipped may effect its performance and cause interference with other
apparatus in the immediate vicinity. If such interference is detected, suitable mitigating
measures should be taken.
4