M52210DEMO Freescale Semiconductor, M52210DEMO Datasheet - Page 6

• Manufacturer Part Number: M52210DEMO
• Description: BOARD DEV MCF5221X LOW COST
• Manufacturer: Freescale Semiconductor
• Series: ColdFire®r
• Type: MCUr

Specifications of M52210DEMO

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MCF52210
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet, USB
• Architecture: 32-bit (not ARM)
• Silicon Manufacturer: Freescale
• Core Architecture: Coldfire
• Core Sub-architecture: Coldfire V2
• Silicon Core Number: MCF52
• Silicon Family Name: MCF5221x
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: MCF5221x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

•
•
Specifications:
Board Size 3.0” x 4.0”
Power Input: +5 to +16 VDC, 9VDC typical
REFERENCES
Reference documents are provided on the support CD in Acrobat Reader format.
M52210DEMO_UG.pdf
M52210DEMO_SCH_C.pdf
M52210DEMO_Silk_C.pdf
M52210DEMO_Assy_C.pdf
CFPRM.pdf
USB_20_05122006.zip
OVERVIEW
The target MCU features an on-board USB On-the-Go (OTG) physical layer (Phy). The OTG
Phy may be configured for either Host or Peripheral mode depending on the target application.
The OTG protocol also allows mode switching under software control. The miniAB (MAB) con-
nector at J2 provides access to the OTG Phy. The USB connection may be configured for ei-
ther standard USB bus operation or OTG USB bus operation.
The MAB USB port connector at J2 should not be confused with the integrated USB BDM cir-
cuit connector at J301. These are 2 separate circuits and do not interact in any way. The
MAB USB port provides access to the integrated USB Phy on the target MCU. The USB BDM
connector allows the user to communicate with the target MCU using either CodeWarrior or
P&E Microcomputer Systems debugger tools and a USB2.0 cable. Remember the distinction
between the 2 USB connectors when reading this document.
The M52210DEMO provides two separate voltage rails for proper operation. The regulator at
VR1 energizes the +3.3V rail for use by the target MCU and on-board logic. The regulator at
VR2 energizes the +5Vrail for use by the OTG USB port.
Connectors
•
•
•
•
•
Supplied with DB9 Serial Cable, USB cable, Ethernet Cable, Support CD, and CodeWarrior Development
Studio CD
RJ-45 Ethernet Connector
Type B USB connector
DB9 Serial Connector
2.0mm Barrel Power Input
2pos, screw type, terminal block
6
M52210DEMO User Guide (this document)
M52210DEMO Schematic, Rev C
M52210DEMO Top Silkscreen, Rev C
M52210DEMO Default Shunt Placement
ColdFire Programmers Reference Manual
USB2.0 Specification and OTG Supplement
with errata