DK-SI-4SGX230N Altera, DK-SI-4SGX230N Datasheet - Page 11

• Manufacturer Part Number: DK-SI-4SGX230N
• Description: KIT DEV STRATIX IV 4SGX230N/C2
• Manufacturer: Altera
• Series: Stratix® IV GXr
• Type: FPGAr

Specifications of DK-SI-4SGX230N

• Contents: Board, Cables, CD, Power Supply
• Silicon Manufacturer: Altera
• Core Architecture: FPGA
• Core Sub-architecture: Stratix
• Silicon Core Number: EP4S
• Silicon Family Name: Stratix IV GX
• Rohs Compliant: Yes
• For Use With/related Products: EP4SGX230
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2592; DK-SI-4SGX230N/C2

Introduction
Powering Up the Board
© February 2009 Altera Corporation
The instructions in this chapter explain how to power up the signal integrity
development board.
To power up the board, perform the following steps:
1. Verify that the MAX/JTAG jumper J26 is OFF, and that the mini-DIP switch SW2
2. Connect the power cable to the board and plug the other end into a power outlet.
3. Connect the DC adapter (+16 V, 3.75 A) to the DC power jack (J1).
4. Ensure the POWER switch (SW1) is in the ON position. When power is supplied to
After the board powers up, the on-board flash memory, which ships preprogrammed
with the factory design, automatically configures the Stratix IV GX device. The
FACTORY LED illuminates, signaling that the Stratix IV GX device is configured with
the preprogrammed factory design.
Switch Pin
Label
Position
settings located adjacent to jumper J62 match the settings in the following table:
1
c
the board, LED D3 turns on indicating that the board has power.
Use only the supplied 16-V power supply. Power regulation circuitry on the
board could be damaged by supplies greater than 16 V.
Maintain these settings as they control the speed of the board oscillator. For
more information, refer to the
Stratix IV GX Edition Reference
up or 0
SW2.1
S0
Transceiver Signal Integrity Development Kit, Stratix IV GX Edition User Guide
down or 1
4. Development Board Setup
Transceiver Signal Integrity Development Kit,
Manual.
SW2.2
S1
down or 1
SW2.3
S2
down or 1
SW2.4
S3