8.10.00 J-TRACE ARM Segger Microcontroller Systems, 8.10.00 J-TRACE ARM Datasheet - Page 27

• Manufacturer Part Number: 8.10.00 J-TRACE ARM
• Description: JTAG EMULATOR ARM7/ARM9 ETM
• Manufacturer: Segger Microcontroller Systems
• Type: Emulatorr

Specifications of 8.10.00 J-TRACE ARM

• Contents: Emulation Module
• For Use With/related Products: ARM7, ARM9
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 899-1006

1.3.3
1.3.3.1 Additional features
1.3.3.2 Specifications
J-Link / J-Trace (UM08001)
J-Link Ultra is a JTAG/SWD emulator designed for ARM/Cortex
and other supported CPUs. It is fully compatible to the standard
J-Link and works with the same PC software. Based on the
highly optimized and proven J-Link, it offers even higher speed
as well as target power measurement capabilities due to the
faster CPU, built-in FPGA and High speed USB interface. It con-
nects via USB to a PC running Microsoft Windows 2000 or later.
For a complete list of all operating systems which are sup-
ported, please refer to Supported OS on page 19.. J-Link Ultra
has a built-in 20-pin JTAG/SWD connector.
•
•
•
•
•
•
•
•
•
•
The following table gives an overview about the specifications (general, mechanical,
electrical) for J-Link Ultra. All values are valid for J-Link Ultra hardware version 1.
Note:
future with newer versions of the J-Link software (freely available).
Table 1.3: J-Link Ultra specifications
Supported OS
Electromagnetic compatibility (EMC)
Operating temperature
Storage temperature
Relative humidity (non-condensing)
Size (without cables)
Weight (without cables)
USB interface
Target interface
External (SPI) analog power measure-
ment interface
Target interface voltage (V
Target supply voltage
Target supply current
Reset Type
Fully compatible to the standard J-Link
Very high performance for all supported CPU cores
Hi-Speed USB 2.0 interface
JTAG speed up to 25 MHz
Serial Wire Debug (SWD) supported
Serial Wire Viewer (SWV) supported
SWV: UART and Manchester encoding supported
SWO sampling frequencies up to 25 MHz
Target power can be supplied
Target power consumption can be measured with high accuracy. External ADC
can be connected via SPI
J-Link Ultra
Some specifications, especially speed, are likely to be improved in the
JTAG/SWD Interface, Electrical
IF
)
Available interfaces
Mechanical
General
© 2004-2011 SEGGER Microcontroller GmbH & Co. KG
For a complete list of all operating sys-
tems which are supported, please refer
to Supported OS on page 21.
EN 55022, EN 55024
+5°C ... +60°C
-20°C ... +65 °C
Max. 90% rH
100mm x 53mm x 27mm
73g
USB 2.0, Hi-Speed
JTAG/SWD 20-pin
4-pin (Pins 14, 16, 18 and 20 of the 20-
pin JTAG/SWD interface)
1.8V ... 5V
4.5V ... 5V
Max. 300mA
Open drain. Can be pulled low or
tristated.
27