STICE-SYS001 STMicroelectronics, STICE-SYS001 Datasheet - Page 16

• Manufacturer Part Number: STICE-SYS001
• Description: EMULATOR FOR STM8
• Manufacturer: STMicroelectronics
• Series: STM8r
• Type: In-Circuit Debugger, Emulator, Programmerr

Specifications of STICE-SYS001

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: STM8
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10029

Emulation configuration
3.2.4
3.2.5
16/26
Analyzer input connector
An analyzer input connector is located on the emulator front panel (see
analyzer input connector allows you to use 8 external input signals (TTL level).
The connector has ten pins—two ground pins (pin 9 and pin 10) and eight input signal pins
(1-8 ), as shown in
Figure 11. Analyzer probe input connections (front view)
A specially adapted 10-wire cable is included to connect your application or an external
device (such as an oscilloscope or multi-meter) to these inlets. Each wire is color-coded as
summarized in
Table 4.
Application power supply follower
Your emulator is equipped with an automatic power supply follower, which converts internal
emulation voltage to the voltage of the application. The application voltage must be within
the range supported by the emulator.
The emulator’s internal power supply regulator supports a V
down to 1.65 V. The lower limit may be higher as it depends on the microcontroller that you
are emulating. For more information about the supported V
refer to your microcontroller datasheet.
Analyzer input pin
Correspondence between analyzer input pin and wiring
Pin 2
Pin 1
10
1
2
3
4
5
6
7
8
9
Table
Figure
4.
11.
Doc ID 13332 Rev 3
4
3
6
5
Signal
Input 1
Input 0
Input 3
Input 2
Input 5
Input 4
Input 7
Input 6
8
GND
GND
7
Pin 10
Pin 9
DD
DD
range for your microcontroller,
voltage up to 5.5 V, and
Wire color
Figure
Orange
Purple
Brown
Yellow
Green
Black
Black
Grey
Blue
Red
8). The
UM0406