STICE-SYS001 STMicroelectronics, STICE-SYS001 Datasheet - Page 20

• Manufacturer Part Number: STICE-SYS001
• Description: EMULATOR FOR STM8
• Manufacturer: STMicroelectronics
• Series: STM8r
• Type: In-Circuit Debugger, Emulator, Programmerr

Specifications of STICE-SYS001

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: STM8
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10029

EMC conformity and safety requirements
Appendix A
20/26
This product respects the EMC requirements of the European guideline 89/336/EEC under
the following conditions:
●
●
●
●
●
●
●
●
Any tester, equipment, or tool used at any production step, or for any manipulation of
semiconductor devices, must have its shield connected to ground.
All provided ferrites must be attached as described in the hardware installation
instructions of the relevant user manual.
The product must be placed on a conductive table top, made of steel or clean
aluminum, grounded through a ground cable. Before every contact with the emulator,
the operator must touch the surface of the grounded worktable just behind the back
panel of the emulator. All manipulation of finished goods must be done at such a
grounded worktable.
The worktable must be free of all non-antistatic plastic objects.
It is recommended that you wear an antistatic wrist or ankle strap, connected to the
antistatic floor covering or to the grounded equipment.
If no antistatic wrist or ankle strap is worn, before each manipulation of the powered-on
tool, you must touch the surface of the grounded worktable just behind the back panel
of the emulator.
It is recommended that antistatic gloves or finger coats be worn.
It is recommended that nylon clothing be avoided while performing any manipulation of
parts.
EMC conformity and safety requirements
Doc ID 13332 Rev 3
UM0406