STICE-SYS001 STMicroelectronics, STICE-SYS001 Datasheet - Page 18

• Manufacturer Part Number: STICE-SYS001
• Description: EMULATOR FOR STM8
• Manufacturer: STMicroelectronics
• Series: STM8r
• Type: In-Circuit Debugger, Emulator, Programmerr

Specifications of STICE-SYS001

• Contents: Main Emulation Board (MEB), Target Emulation Board (TEB), Cables, Power Supply and Documentation
• For Use With/related Products: STM8
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 497-10029

In-circuit programming/debugging configuration
4
4.1
Figure 12. In-circuit programming/debugging configuration
18/26
USB connection
to the host PC
STVD for ICP and ICD, or
In-circuit programming/debugging configuration
In the in-circuit programming (ICP) / in-circuit debugging (ICD) configuration, STice provides
the capability to program your application to your microcontroller and to debug your
application as it runs on the microcontroller on your application board. The following
sections provide information about:
●
●
Setting up the system for in-circuit programming/debugging
The STice features an in-circuit programming/debugging (ICD/ICP) port that allows you to
take advantage of the single wire interface module (SWIM) protocol for STM8 to program an
application to the microcontroller on your application board and debug the application while
it runs on the target device.
Host PC running
During application development, STVD software running on your PC provides an integrated
development environment that allows you to debug your application while it runs on your
microcontroller. For more information about in-circuit debugging with STVD, refer to the
STVD online help provided with your software package.
STVD also provides a microcontroller programming interface that supports in-circuit
programming of STM8, or you can use the ST Visual Programming (STVP) interface, which
provides a full-featured graphical interface for verifying memory sectors, checking the
settings of the option bytes and programming the MCU. For more information about
programming with STVP, refer to the STVP online help.
STVP for ICP
Section 4.1
Section 4.2
– Setting up the STice to operate in ICD/ICP configuration
– SWIM connection for ICD/ICP of an STM8 microcontroller
An ICD/ICP connector is relayed to the STM8
microcontroller and allows the connection of
the flat cable from
Doc ID 13332 Rev 3
STice
Your microcontroller
.
STice
panel (inset) for ICD/ICP using SWIM
features an ICD/ICP port on the right
Right panel
/ICP
UM0406