HS2633REPI61H-U Renesas Electronics America, HS2633REPI61H-U Datasheet - Page 202

• Manufacturer Part Number: HS2633REPI61H-U
• Description: EMULATOR BASE UNIT H8S/2633R FAM
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS2633REPI61H-U

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8S/2633R
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[General] page (cont)
The MCUs selectable by the [Device] option and options that depend on the MCUs are listed below. To emulate
an MCU with a description in the Expansion Hardware column, connect the correct expansion hardware.
Table 8.2
[Device] Option
Custom
H8S/2238
H8S/2237
H8S/2236
H8S/2235
H8S/2233
H8S/2227
H8S/2225
H8S/2223
H8S/2224
H8S/2258
H8S/2256
Notes: 1.
182
[Break on access error]
[Enable internal ROM area write]
[User VCC Threshold]
[User Signals]
[Driver]
[Change driver in start up]
2.
3.
4.
Environment for the E6000 H8S/2237 Emulator CPU 2000 Debugging Platform
Target in [Mode] is only available when the target system is connected.
Target and Target/2 in [Clock] are only available when the target system is connected.
In the H8S/2258, H8S/2238, H8S/2237, and H8S/2227 group, the maximum operating
frequency of the actual MCU is 13.5 MHz.
IEBus
[Mode] Option
The MCU previously selected
4 (advanced mode, 16bit Bus)
5 (advanced mode, 8bit Bus)
6 (advanced mode, on-chip ROM)
7 (advanced mode, single chip)
Target
TM
(Inter Equipment Bus
When this box is checked, a break (the user program stops) occurs if
your program accesses an access-prohibited area or writes to a write-
protected area.
When this box is checked, writing to the internal ROM area is enabled.
For the result of writing, see the [Extended Monitor] window.
Sets the voltage level for the user system. [Down] will be displayed in
[User System Voltage] of the [Extended Monitor] window when the actual
user VCC (PVCC when the E6000 H8S/2633 Emulator CPU debugging
platform is selected) of the target system is lower than the specified
value.
signals from the user system are enabled. Note that the standby signal is
always invalid because the hardware standby function is not supported.
However, the status of the signal can be checked in the [Extended
Monitor] window.
Displays the E6000 driver that is currently installed.
When this box is checked, selection of a driver will be available next time
the emulator is connected.
When this box is checked, the reset, NMI, standby, and bus request
TM
) is a trademark of NEC Corporation.
[Clock] Option
Main: 10MHz, Sub: 32kHz
Main: 20MHz, Sub: 32kHz
Main: 10MHz, Sub: Target
Main: 20MHz, Sub: Target
Main: Target, Sub: Target
Main: Target/2, Sub: Target
Expansion Hardware
HS2258EIO61H
(IEBus
TM
board)