EPSILON5-UPG15 Equinox Technologies, EPSILON5-UPG15 Datasheet - Page 31

• Manufacturer Part Number: EPSILON5-UPG15
• Description: UPGRADE EPSILON ATMEL AT91SAM7
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Upgrade Kitr

Specifications of EPSILON5-UPG15

• For Use With/related Products: Epsilon5
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

7
8
9
10
11
12
13
14
20
Select the required ISP Header and then plug
the ISP Cable into this Header.
Please refer to section 4.
Connect 3.0-5.0V to CON1 via supplied lead
(white stripe is +ve)
or
Fit J9 and connect ISP Cable to powered
Target System
Please refer to section 3 for further details.
Remove power from programmer
Re-fit lid to programmer
Re-fit the four screws in the back of the case
Ensure that the PC, programmer and Target
System power is switched OFF.
Connect the PC serial cable to the
programmer RS-232 port (J5) and connect
the other end of the cable to a spare PC
COM port.
See section 1.5.6 for Serial Cable
specifications.
Connect the ISP cable to the ISP Header on
your Target System
Apply power to the programmer
EPSILON5 MKII Programmer - User Guide V1.12 – 1
!!! WARNING !!!
Vcc’ LED will illuminate.
The ISP Cable should fit through the slot in the
end panel.
Programmer circuitry powers up to 3.0V.
If the Jumper Link J9 is fitted then the ‘Target
All LED’s go out
programmer firmware is being updated.
•
•
If you select the wrong ISP Header
then it is possible that you may
damage both the programmer and
Target System when power is
switched on.
Please ensure you are using the
correct header. If in doubt, please
refer to section 4 of this manual and /
or contact Equinox Support for
assistance.
st
August 2007