EPSILON5-UPG15 Equinox Technologies, EPSILON5-UPG15 Datasheet - Page 66

• Manufacturer Part Number: EPSILON5-UPG15
• Description: UPGRADE EPSILON ATMEL AT91SAM7
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Upgrade Kitr

Specifications of EPSILON5-UPG15

• For Use With/related Products: Epsilon5
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.6.4 Set up instructions - Programmer and Target System independently
powered
The instructions below detail how to set up the programmer / Target System so that they are
independently powered.
Status LED key:
#
1
2
3
4
5
6
7a
7b
7c
8
EPSILON5 MKII Programmer - User Guide V1.12 – 1
Action
Remove programmer cover and remove
Jumper J9.
Ensure that the programmer is NOT
connected to the Target System via the ISP
Connector
Connect the ISP cable between correct ISP
Header on the programmer and the ISP
Header on the Target System.
Apply required voltage (3.0V to 5.0V DC) to
Con1 Power Connector from external Power
Supply.
Note – This voltage is NOT applied to the
Target System as J9 is removed.
Apply power to Target System from an
external supply (V_TVCC must be 3.1 – 5.0V)
Check the Target Vcc voltage (V_TVCC) is
3.1 – 5.0V using a volt meter
Press
There is no valid Programming Project in the
Programmer.
You need to upload a Programming
Project before using the programmer in
Standalone Mode.
There is a valid Programming Project in the
Programmer.
Remove power from programmer
button once
st
August 2007
Observation
This disconnects the
Programmer Vcc (from
Con1) to the Target Vcc.
All LED’s are OFF
Programmer and Target
system are NOT powered.
All LED’s are OFF
Programmer and Target
system are NOT powered
circuitry powers up to 3.0V
to V_TVCC
V_TVCC = 3.1 – 5.0V
Pressing any button will have
no effect.
‘Autoprogram Mode’.
Press the <YES> button
again to execute the
Programming Project.
Programmer internal
Target System powers up
Target Vcc LED illuminates
7a or 7b
FAIL LED starts flashing.
programmer is now in
All LED’s go out
Status of LED’s
55