63811-5200 Molex Inc, 63811-5200 Datasheet - Page 3

• Manufacturer Part Number: 63811-5200
• Description: TOOL HAND CRIMP 22-28AWG
• Manufacturer: Molex Inc
• Series: SPOX™r
• Type: Crimp Toolr

Specifications of 63811-5200

• Tool Type: Hand Crimper
• Features: Side Entry, Ratchet
• Product: Crimping, Stripping & Cutting Tools & Drills
• Crimp Size: 28AWG To 22AWG
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Rectangular Contacts, 22-28 AWG
• For Use With: WM18783 - CONN TERM FEMALE 22-28AWG TINWM18889CT - CONN FEMALE 22-28AWG 2.5MM TINWM18889TR - CONN FEMALE 22-28AWG 2.5MM TINWM17406 - CONN TERM FEMALE 22-28AWG CRIMP
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 063811-5200; 063811-5200-P; 0638115200; 0638115200-P; 63811-5200-P; 638115200; 638115200-P; WM18830

Hand Crimp Tool for SPOX™ Terminals
Doc No: ATS- 638115200
Revision: B
LOCATOR
SWING
PRESS DOWN
OPEN
PIVOT SHAFT
7. Remove the crimped terminal from the terminal locator by pressing
8. Visually inspect the crimped terminal for proper crimp location.
Note:
A crimp height chart is provided with this manual as Reference Only.
Due to the wide range of wires, strands, insulation diameters, and
durometers, actual crimp height measurements may very slightly. An
occasional, destructive, pull force test should be preformed to check
hand tool crimp. Pull Force value Must exceed the Minimum pull force
specifications listed on page 2.
OPEN WIRE STOP
ON BRASS
PUSH HERE TO
down on the wire stop and gently pulling on the wire. The terminal
locator can be in either position.
Note: The tamper proof ratchet action will not release the tool until it has been fully closed.
LIFT UP LOCATOR
LOCATOR
Release Date: 04-03-06
Revision Date: 11-29-07
SWING OPEN
TERMINAL
Figure 4
Figure 2
JAWS OPEN
LOCATOR
TERMINAL IN PLACE
Locator Change Over and Replacement
Multiple styles of locators maybe provided with the crimp hand
tool. They are different colors for easy identification. See the
parts list on the last page of the document. Make sure the
desired style of locator is installed for the proper terminal and
wire. Follow the steps below to change the locators.
1. Open the crimp hand tool.
2. Swing the existing locator open and away from the hand
3. Firmly press down on the brass pivot shaft with your
4. Replace it with the desired locator by putting over the
UNCONTROLLED COPY
tool.
thumb, while pulling the locator up. Slip the locator off
the top of the brass pivot shaft. See Figure 4.
brass pivot shaft and snapping it into place.
LOCATOR
IN PLACE
WIRE STOP
WIRE AGAINST
WIRE STOP
STOP
Figure 3
Page 3 of 6
TERMINAL
WIRE