1213860-1 Tyco Electronics, 1213860-1 Datasheet - Page 3

• Manufacturer Part Number: 1213860-1
• Description: CERTI-CRIMP II ADAPT-SDE BENCH
• Manufacturer: Tyco Electronics
• Series: Certi-Crimp™r

Specifications of 1213860-1

• Accessory Type: Handle
• Tool Type: Tool Holder Assembly
• For Use With/related Products: SDE Electric Bench Terminator
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

As supplied, the tool holder assembly has three
quick–release pins installed (Figure 2 and Figure 4 ).
The two outer pins will be used to secure the two
outer housing tabs of the crimp head (exposed
portion of the crimp head) to the tool holder assembly.
The center pin will be used to secure the movable die
of the crimp head to the ram of the tool holder
assembly.
Rev
Switch
(Handle)
Guide
Ram
Quick-
Release
Pins
A
Figure 3
Figure 4
Guide Pin Removed
CERTI-CRIMP II Tool Holder Assembly 1213860-1
A. Installation
These pins must be removed prior to installing the
crimping head.
The finished assembly should appear as shown in
Figure 5.
B. Removal
To remove the crimping head, it will be necessary to
remove the three quick–release pins, and then
remove the crimp head from the tool holder assembly.
4. CRIMP HEIGHT ADJUSTMENT
Crimp height adjustment is required only if the crimp
height listed in the Tyco Electronics die specification
is not achieved.
Quick-
Release
Pins
Tool
Holder
Assembly
1. Remove the quick–release pins shown in
Figure 4.
2. Insert the exposed portion of the crimping head
into the tool holder assembly cavity.
3. Insert the two outer quick–release pins through
the holes in the tool holder assembly, and through
the holes in the two outer tabs of the crimping
head.
NOTE
4. Insert the center quick–release pin into the tool
holder assembly and through the holes in the ram
and the moveable die of the crimp head.
NOTE
The outer quick-release pins will snap" into
position when they are properly inserted.
The center quick-release pin will snap" into
position when it is properly inserted.
Figure 5
408-10021
SDE
Electric
Terminator
(Typical)
Crimping
Head
Quick-
Release
Pin
3
of 5