1-45160-0 Tyco Electronics, 1-45160-0 Datasheet - Page 5

• Manufacturer Part Number: 1-45160-0
• Description: TOOL HEAD CRIMP 22-16AWG P-G
• Manufacturer: Tyco Electronics
• Series: Plasti-Grip™r

Specifications of 1-45160-0

• Connector Type: Terminals and Splices
• Crimp Handle: 1213563-1, 1213804
• Crimp Or Cable Size: 16-22 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable

If the crimping chamber passes the gage inspection,
the crimping head is considered dimensionally correct
and should be lubricated with a THIN coat of any
good SAE 20 motor oil. If the crimping chamber does
not conform to the plug gage conditions, contact your
local Tyco Electronics Field Representative or refer to
Section 7, REPLACEMENT AND REPAIR.
For additional information about the use of a plug
gage, see Instruction Sheet 408–7424.
Rev
Detail A
GO element must pass
completely through the
crimping chamber.
4. Align the NO–GO element and try to insert it
into the chamber. The element may start entry, but
it must not pass completely through the crimping
chamber.
5. Repeat this procedure for the insulation crimping
section using a plug gage as shown in Figure 7B.
Wire Barrel
Plug Gage
A
É É
É É É É
É É
GO Element
Crimping
Chamber
NO-GO element may enter
partially, but must not pass
completely through the
crimping chamber.
É
É É
É
Wire Barrel
Section
NO-GO Element
PLASTI-GRIP Butt Splice Crimping Heads
Inspection of Crimping Chamber
Figure 7
7. REPLACEMENT AND REPAIR
Replacement parts and recommended spares are
listed in Figure 8. The recommended spares should
be stocked for immediate replacement.
Order replacement parts through your Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
For further repair and replacement information,
call the Tyco Electronics Tooling Assistance Center at
the number at the bottom of page 1.
8. REVISION SUMMARY
É É
É É É É
É É
Detail B
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
GO element must pass
completely through the
crimping chamber.
S Initial release of document
Insulation Barrel
Section
GO Element
Crimping
Chamber
NO-GO element may enter
partially, but must not pass
completely through the
crimping chamber.
É É
É É É É
É É
Insulation Barrel
Plug Gage
Insulation Adjustment
Pins in Position 1
NO-GO Element
408-10030
5
of 6