679301-1 Tyco Electronics, 679301-1 Datasheet - Page 2

• Manufacturer Part Number: 679301-1
• Description: TOOL 22-10AWG SOLIS CRIMP HEAD
• Manufacturer: Tyco Electronics

Specifications of 679301-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

3.2. Removal
Remove quick pins from the crimping head; then
remove crimping head from the tool holder.
4. CRIMPING PROCEDURES
{
2
626 Pneumatic Crimping Heads
DANGER
DANGER
CRIMPING
Trademark of Loctite Corporation
1. Remove quick pins from tool holder.
2. Insert crimping head into tool holder as shown in
Figure 1.
3. After crimping head is properly aligned, insert
and tighten the quick pins provided with the tool
holder assembly.
NOTE
4. Connect tool to an adequate air supply between
620–690 kPa [90–100 psi]. For specific information
on air line requirements and air hose installation,
refer to the customer manual packaged with the
pneumatic power unit.
NOTE
HEAD
i
i
RANGE
(AWG)
(AWG)
WIRE
WIRE
MIN
STANDARD
TERMINAL
MAX
{
MIN
LONG BARREL
Figure 2
TERMINAL
WIRE STRIP LENGTH
NOTE
1. Strip wire to the dimension shown in Figure 2.
DO NOT nick the wire strand or use wires with
nicked or missing conductor strands.
2. Open crimping jaws by squeezing the rollers
simultaneously; then place the terminal or splice
into the center of the appropriate crimping
chamber. Use the correct crimp chamber for the
specific wire size. Refer to Figures 3, 4, and 5.
NOTE
3. After terminal or splice is properly positioned,
release rollers to allow the jaws to spring shut,
holding terminal or splice in place.
4. Insert stripped wire, as shown in Figures 3, 4,
and 5. DO NOT allow wire insulation to enter
terminal or splice wire barrel.
MAX
i
i
MIN
BUTT SPLICE
Crimping SOLISTRAND Terminal
Figure 3
MAX
PARALLEL SPLICE
MIN
408-4072
MAX
D