VT-750C Master Appliance Co, VT-750C Datasheet - Page 8

• Manufacturer Part Number: VT-750C
• Description: VARTEMP HEAT GUN 1000F MAX 120V
• Manufacturer: Master Appliance Co
• Series: Varitemp®r
• Type: Heat Gunr

Specifications of VT-750C

• Temperature Range: 1000°F (538°C)
• Voltage: 120V
• Current: 14.5A
• Power - Rated: 1740W
• Supply Voltage Vac: 120V
• Heat Temperature Range: 540°C
• Power Rating: 1740W
• Operating Temperature Max: 1000°F
• Peak Reflow Compatible (260 C): No
• Supply Voltage: 120VAC
• Leaded Process Compatible: No
• Application: Use to activate adhesives, defrost frozen coils, heat sensitive material, melt solder, soften plastics and more
• Cordset: 6 ft., 3-Wire Grounded
• Current Rating: 14.5
• Diameter, Nozzle: 1.2 in.
• Dimensions: 9 in. L x 6.5 in. W x 10.1 in. H
• Motor Type: Universal
• Power Output: 1740 W
• Standards: cUL Listed
• Temperature, Variable: 540 °C
• Velocity, Airflow: 3000 FPM
• Voltage, Rating: 120 V
• Volume, Airflow: 23
• Weight: 3.8 lb.
• Operating Current: 14.5A
• Air Volume: 23CFM
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• Lead Free Status / Rohs Status: RoHS Exempt Product

Shrinking Tubing
Use stand to free both hands.
Slide tubing over area to be
insulated. Place in air stream
and move with a side to side
motion until tubing has
shrunk. Remove from air
stream.
Shrinking Packaging
After shrink wrap has been
sealed around product, poke
a small hole in it to allow
Typical Applications
4) When the task is
completed, move rocker
switch to "Cool" position.
Allow blower to operate for
a few minutes on cool.
(cont’d)
trapped air to escape. Then
wave heated air stream back
and forth across package until
shrink wrap has evenly
shrunk.
Removing Floor Tile
Direct heated air stream at tile
to be removed in a back and
forth motion. This will soften
the adhesive backing. Place
putty knife under tile and lift to
remove.
Bending and Forming
Plastics
Experiment with a piece of
scrap material first to develop
a proper technique. Place
8
plastic piece into a proper
holding fixture. Wave hot air
along the whole length of the
“Bend” line until plastic
softens along that area. Bend
plastic to desired position.
Removing Old Putty
When removing putty from a
broken window, carefully
remove the broken glass first.
When removing putty from an
undamaged window, direct
the hot air stream away from
the glass to prevent cracking
due to thermal shock. It is
convenient to shield the glass
from the hot air with a large
putty knife. Wave the hot air
stream at putty until softened.
Remove with putty knife.