XBIB-U Digi International/Maxstream, XBIB-U Datasheet - Page 48

• Manufacturer Part Number: XBIB-U
• Description: BOARD USB ZIGBEE MOD PRO
• Manufacturer: Digi International/Maxstream

Specifications of XBIB-U

• Design Resources: XBIB-U Shematic
• Accessory Type: Interface Board
• For Use With/related Products: XBee and XBee Pro Radios
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

XBee/XBee‐PRO™ OEM RF Modules ‐ 802.15.4 ‐ v1.xAx [2007.05.031]
P0 (PWM0 Configuration) Command
P1 (PWM1 Configuration) Command
PL (Power Level) Command
<I/O Setting {I/O Line Passing}> The P0 com-
mand is used to select/read the function for
PWM0 (Pulse Width Modulation output 0). This
command enables the option of translating
incoming data to a PWM so that the output can be
translated back into analog form.
With the IA (I/O Input Address) parameter cor-
rectly set, AD0 values can automatically be
passed to PWM0.
<I/O Setting {I/O Line Passing}> The P1 com-
mand is used to select/read the function for
PWM1 (Pulse Width Modulation output 1). This
command enables the option of translating
incoming data to a PWM so that the output can be
translated back into analog form.
With the IA (I/O Input Address) parameter cor-
rectly set, AD1 values can automatically be
passed to PWM1.
<RF Interfacing> The PL command is used to
select and read the power level at which the RF
module transmits conducted power.
WHEN OPERATING IN EUROPE:
XBee-PRO RF Modules must be configured to
operate at a maximum transmit power output
level of 10 dBm. The PL parameter must equal “0”
(10 dBm).
Additionally, European regulations stipulate an
EIRP power maximum of 12.86 dBm (19 mW) for
the XBee-PRO and 12.11 dBm for the XBee when
integrating high-gain antennas.
WHEN OPERATING IN JAPAN:
XBee-PRO RF Modules optimized for use in Japan contain firmware that limits transmit power out-
put to 10 dBm. If PL=4 (default), the maximum power output level is 10 dBm. For a list of module
part numbers approved for use in Japan, contact MaxStream [call 1-801-765-9885 or send e-mail
to [e-mail]].
© 2007 MaxStream, Inc.
AT Command: ATPL
Parameter Range: 0 - 4
Default Parameter Value: 4
AT Command: ATP0
The second character in the command is the
number zero (“0”), not the letter “O”.
Parameter Range: 0 - 2
AT Command: ATP1
Parameter Range: 0 - 2
Default Parameter Value: 0
Minimum Firmware Version Required: v1.xA0
Default Parameter Value: 1
Parameter
0
1
2
3
4
Parameter
Parameter
Chapter 3 ‐ RF Module Configuration
0
1
2
0
1
2
-10 dBm
-6 dBm
-4 dBm
-2 dBm
0 dBm
XBee
Configuration
Configuration
PWM0 Output
PWM1 Output
Disabled
Disabled
RSSI
RSSI
XBee-PRO
10 dBm
12 dBm
14 dBm
16 dBm
18 dBm
48