XBIB-U Digi International/Maxstream, XBIB-U Datasheet - Page 5

• Manufacturer Part Number: XBIB-U
• Description: BOARD USB ZIGBEE MOD PRO
• Manufacturer: Digi International/Maxstream

Specifications of XBIB-U

• Design Resources: XBIB-U Shematic
• Accessory Type: Interface Board
• For Use With/related Products: XBee and XBee Pro Radios
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

XBee/XBee‐PRO™ OEM RF Modules ‐ 802.15.4 ‐ v1.xAx [2007.05.031]
Antenna Options: The ranges specified are typical when using the integrated Whip (1.5 dBi) and Dipole (2.1 dBi) anten-
nas. The Chip antenna option provides advantages in its form factor; however, it typically yields shorter range than the
Whip and Dipole antenna options when transmitting outdoors. For more information, refer to the “XBee Antenna” appli-
cation note located on MaxStream’s web site (http://www.maxstream.net/support/knowledgebase/article.php?kb=153).
1.2. Specifications
Table 1‐01. Specifications of the XBee/XBee‐PRO OEM RF Modules
* When operating in Europe: XBee‐PRO RF Modules must be configured to operate at a maximum transmit power output level
of 10 dBm. The power output level is set using the PL command. The PL parameter must equal “0” (10 dBm).
Additionally, European regulations stipulate an EIRP power maximum of 12.86 dBm (19 mW) for the XBee‐PRO and 12.11 dBm
for the XBee when integrating high‐gain antennas.
** When operating in Japan: Transmit power output is limited to 10 dBm. A special part number is required when ordering
modules approved for use in Japan. Contact MaxStream for more information [call 1‐801‐765‐9885 or send e‐mails to sales@max‐
stream.net].
Specification
Performance
Indoor/Urban Range
Outdoor RF line-of-sight Range
Transmit Power Output
(software selectable)
RF Data Rate
Serial Interface Data Rate
(software selectable)
Receiver Sensitivity
Power Requirements
Supply Voltage
Transmit Current (typical)
Idle / Receive Current (typical)
Power-down Current
General
Operating Frequency
Dimensions
Operating Temperature
Antenna Options
Networking & Security
Supported Network Topologies
Number of Channels
(software selectable)
Addressing Options
Agency Approvals
United States (FCC Part 15.247)
Industry Canada (IC)
Europe (CE)
Japan
© 2007 MaxStream, Inc.
XBee
up to 100 ft. (30 m)
up to 300 ft. (100 m)
1mW (0 dBm)
250,000 bps
1200 - 115200 bps
(non-standard baud rates also supported)
-92 dBm (1% packet error rate)
2.8 – 3.4 V
45mA (@ 3.3 V)
50mA (@ 3.3 V)
< 10 µA
ISM 2.4 GHz
0.960” x 1.087” (2.438cm x 2.761cm)
-40 to 85º C (industrial)
Integrated Whip, Chip or U.FL Connector
Point-to-point, Point-to-multipoint & Peer-to-peer
16 Direct Sequence Channels
PAN ID, Channel and Addresses
OUR-XBEE
4214A XBEE
ETSI
n/a
Chapter 1 ‐ XBee/XBee‐PRO OEM RF Modules
XBee-PRO
Up to 1 mile (1500 m)
60 mW (18 dBm) conducted, 100 mW (20 dBm) EIRP*
250,000 bps
1200 - 115200 bps
(non-standard baud rates also supported)
2.8 – 3.4 V
If PL=0 (10dBm): 137mA(@3.3V), 139mA(@3.0V)
PL=1 (12dBm): 155mA (@3.3V), 153mA(@3.0V)
PL=2 (14dBm): 170mA (@3.3V), 171mA(@3.0V)
PL=3 (16dBm): 188mA (@3.3V), 195mA(@3.0V)
PL=4 (18dBm): 215mA (@3.3V), 227mA(@3.0V)
< 10 µA
0.960” x 1.297” (2.438cm x 3.294cm)
-40 to 85º C (industrial)
Integrated Whip, Chip or U.FL Connector
PAN ID, Channel and Addresses
OUR-XBEEPRO
4214A XBEEPRO
ETSI (Max. 10 dBm transmit power output)*
005NYCA0378 (Max. 10 dBm transmit power output)**
Up to 300’ (100 m)
-100 dBm (1% packet error rate)
55mA (@ 3.3 V)
ISM 2.4 GHz
12 Direct Sequence Channels
5