AD14060BF-4 Analog Devices Inc, AD14060BF-4 Datasheet - Page 33

• Manufacturer Part Number: AD14060BF-4
• Description: IC DSP CMOS 32BIT 308CQFP
• Manufacturer: Analog Devices Inc
• Series: SHARC®r
• Type: Fixed/Floating Pointr

Specifications of AD14060BF-4

• Rohs Status: RoHS non-compliant
• Interface: Host Interface, Link Port, Serial Port
• Clock Rate: 40MHz
• Non-volatile Memory: External
• On-chip Ram: 2MB
• Voltage - I/o: 5.00V
• Voltage - Core: 5.00V
• Operating Temperature: -40°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 308-CQFP
• Device Core Size: 32b
• Architecture: Enhanced Harvard
• Clock Freq (max): 40MHz
• Mips: 40
• Device Input Clock Speed: 40MHz
• Ram Size: 1.9073535156MB
• Operating Supply Voltage (typ): 5V
• Operating Supply Voltage (min): 4.75V
• Operating Supply Voltage (max): 5.25V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 308
• Package Type: CQFP
• Lead Free Status / Rohs Status: Not Compliant

Pin
TDI
TDO
TRST
EMU (O/D)
V
GND
FLAG3 is connected internally, common to SHARC_A, B, C, and D.
ID pins are hardwired internally as shown in Figure 1.
1
2
3
I = input; P = power supply; (A/D) = active drive; O = output; S = synchronous; (O/D) = open drain; G = ground; A = asynchronous; T = three-state, when SBTS is
asserted, or when the AD14060/AD14060L is a bus slave.
Link Ports 0, 2, and 5 are connected internally, as described in the Li
Three-statable only in EPROM boot mode (when BMS is an output).
DD
Type
I/S
O
I/A
O
P
G
1
Function
Test Data Input (JTAG). Provides serial data for the boundary scan logic chain starting at SHARC_A. TDI has a 20 kΩ
internal pull-up resistor.
Test Data Output (JTAG). Serial scan output of the boundary scan chain path, from SHARC_D.
Test Reset (JTAG) (common to all SHARCs). Resets the test state machine. TRST must be asserted (pulsed low) after
power-up or held low for proper operation of the AD14060/AD14060L. TRST has a 20 kΩ internal pull-up resistor.
Emulation Status (common to all SHARCs). Must be connected to the ADSP-2106x EZ-ICE target board connector
only.
Power Supply. Nominally 5.0 V dc for 5 V devices or 3.3 V dc for 3.3 V devices (26 pins).
Power Supply Return (28 pins).
nk Port I/O
Rev. B | Page 33 of 48
section.
AD14060/AD14060L