ISP1302HN-T ST-Ericsson Inc, ISP1302HN-T Datasheet - Page 50

• Manufacturer Part Number: ISP1302HN-T
• Description: IC USB OTG TRANSCEIVER 24HVQFN
• Manufacturer: ST-Ericsson Inc
• Type: Transceiverr

Specifications of ISP1302HN-T

• Number Of Drivers/receivers: 1/1
• Protocol: USB 2.0
• Voltage - Supply: 3 V ~ 4.5 V
• Mounting Type: Surface Mount
• Package / Case: 24-VQFN Exposed Pad, 24-HVQFN, 24-SQFN, 24-DHVQFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

NXP Semiconductors
ISP1302_1
Product data sheet
14.2.1 Test 1
14.2.2 Test 2
14.2.3 Test 3
14.2 Audio crosstalk test conditions
14.3 Data to audio isolation test conditions
V
Fig 22. V
CC
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
SW2 = on and SW3 = on.
DP is terminated using a 200
MIC is terminated using a 10 k resistor, and SPKR_L is terminated using a 200
resistor, 1.4 V DC.
Drive f = 1 kHz, V = 1 V (p-p) to DP; signal on DM must be 66 dB below.
SW1 = on and SW3 = on.
DP and DM are terminated using a 60 k resistor.
SPKR_L and SPKR_R are terminated using a 200
Drive f = 1 kHz, V = 1 V (p-p) to SPKR_R; signal on DM must be 66 dB below.
SW1 = on and SW3 = on.
DP and DM terminated using a 60 k resistor.
SPKR_L and SPKR_R terminated using a 200
Drive f = 1 kHz, V = 1 V (p-p) to SPKR_L; signal on DP must be 66 dB below.
V
12 Mbit/s USB data is to be active on the DP and DM pins.
All audio switches must be left open.
MIC must be terminated using a 10 k resistor.
SPKR_L and SPKR_R are each to be terminated using a 200
Taking an FFT on the SPKR_R/MIC and SPKR_L pins, USB data components below
20 kHz will be < 70 dB below the USB data level (3.6 V).
sweeps from 2.9 V to 4.2 V (DC waveform).
CC
is swept from 2.9 V to 4.2 V (DC waveform).
CC
with 217 Hz noise
V
V
max
min
= 3.4 V to 4.2 V
= 2.9 V to 3.7 V
Rev. 01 — 24 May 2007
500 mV
resistor, and DM is terminated using a 60 k resistor.
577 s
USB OTG transceiver with carkit support
4.6 ms
resistor, 1.4 V DC.
resistor, 1.4 V DC.
004aaa519
30 s
resistor.
© NXP B.V. 2007. All rights reserved.
ISP1302
49 of 63