SAM9261 Atmel Corporation, SAM9261 Datasheet - Page 37

• Manufacturer Part Number: SAM9261
• Manufacturer: Atmel Corporation

Specifications of SAM9261

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 160
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

10.10 Synchronous Serial Controller
10.11 Timer Counter
10.12 Multimedia Card Interface
6062LS–ATARM–23-Mar-09
• Test Modes
• Provides serial synchronous communication links used in audio and telecom applications
• Contains an independent receiver and transmitter and a common clock divider.
• Offers a configurable frame sync and data length.
• Receiver and transmitter can be programmed to start automatically or on detection of
• Receiver and transmitter include a data signal, a clock signal and a frame synchronization
• Three 16-bit Timer Counter Channels
• Wide range of functions including:
• Each channel is user-configurable and contains:
• Two global registers that act on all three TC Channels
• Compatibility with MultiMedia Card Specification Version 2.2
• Compatibility with SD Memory Card Specification Version 1.0
• Cards clock rate up to Master Clock divided by 2
• Embedded power management to slow down clock rate when not used
• Each MCI has two slots, each supporting
• Support for stream, block and multi-block data read and write
(with CODECs in Master or Slave Modes, I
more).
different event on the frame sync signal.
signal.
– Remote Loopback, Local Loopback, Automatic Echo
– Frequency Measurement
– Event Counting
– Interval Measurement
– Pulse Generation
– Delay Timing
– Pulse Width Modulation
– Up/down Capabilities
– Three external clock inputs
– Five internal clock inputs
– Two multi-purpose input/output signals
– One slot for one MultiMedia Card bus (up to 30 cards) or
– One SD Memory Card
2
S, TDM Buses, Magnetic Card Reader and
AT91SAM9261
37