ST10F269Z2 STMicroelectronics, ST10F269Z2 Datasheet - Page 29

• Manufacturer Part Number: ST10F269Z2
• Description: 16-bit MCU
• Manufacturer: STMicroelectronics

Specifications of ST10F269Z2

• Single Voltage Supply: 5V ±10% (EMBEDDED REGULATOR FOR 2.7 or 3.3 V CORE SUPPLY).
• Temperature Ranges: -40 +125 °C / -40 to 85 °C

ST10F269
EXTS
MOV
Data_Polling:
EXTS
MOV
MOV
XOR
JNB
JNB
EXTS
MOV
XOR
JNB
Prog_Error:
MOV
EXTS
MOV
...
...
...
Prog_OK:
....
....
R11, #1
[R12], R13
R11, #1
R7, [R12]
R6, R7
R7, R13
R7.7, Prog_OK
R6.5, Data_Polling
R11, #1
R7, [R12]
R7, R13
R7.7, Prog_OK
R7, #0F0h
R11, #1
[R12], R7
;R12 contains the segment offset address to be
;programmed
;R13 contains the data to be programmed
;use EXTended addressing for next MOV instruction
;command cycle 4: the EPC starts execution of
;Programming Command
;use EXTended addressing for next MOV instruction
;read Flash Status register (FSB) in R7
;save it in R6 register
;Check if FSB.7 = Data.7 (i.e. R7.7 = R13.7)
;Check if FSB.5 = 1 (Programming Error)
;Programming Error: verify is Flash programmed
;data is OK
;use EXTended addressing for next MOV instruction
;read Flash Status register (FSB) in R7
;Check if FSB.7 = Data.7
;Programming failed: Flash remains in Write
;Operation.
;To go back to normal Read operations, a Read/Reset
;command
;must be performed
;load register R7 with Read/Reset command
;use EXTended addressing for next MOV instruction
;address is don’t care for Read/Reset command
;here place specific Error handling code
;When programming operation finished succesfully,
;Flash is set back automatically to normal Read Mode
5 - INTERNAL FLASH MEMORY
29/184