tmp88ps42ng TOSHIBA Semiconductor CORPORATION, tmp88ps42ng Datasheet - Page 187

• Manufacturer Part Number: tmp88ps42ng
• Description: 8 Bit Microcontroller Tlcs-870/x Series
• Manufacturer: TOSHIBA Semiconductor CORPORATION

15.4 Number of bits to transfer
15.5 Number of words to transfer
15.3.2 Shift edge
the transmit/receive data buffer register are used. The upper 4 bits are cleared to “0” when receiving.
The data is transferred in sequence starting at the least significant bit (LSB).
ferred continuously. The number of words to be transferred can be selected by SIOCR2<BUF>.
words is to be changed during transfer, the serial interface must be stopped before making the change. The number
of words can be changed during automatic-wait operation of an internal clock. In this case, the serial interface is not
required to be stopped.
15.3.2.1 Leading edge
15.3.2.2 Trailing edge
Either 4-bit or 8-bit serial transfer can be selected. When 4-bit serial transfer is selected, only the lower 4 bits of
Up to 8 words consisting of 4 bits of data (4-bit serial transfer) or 8 bits (8-bit serial transfer) of data can be trans-
An INTSIO interrupt is generated when the specified number of words has been transferred. If the number of
The leading edge is used to transmit, and the trailing edge is used to receive.
output).
put).
Transmitted data are shifted on the leading edge of the serial clock (falling edge of the
Received data are shifted on the trailing edge of the serial clock (rising edge of the
SCK pin
SO pin
SCK pin
SI pin
Shift register
Shift register
****
Figure 15-5 Shift edge
3210
Bit 0
Bit 0
(a) Leading edge
(b) Trailing edge
0 ***
Page 177
* 321
Bit 1
Bit 1
10 **
Bit 2
** 32
Bit 2
210 *
Bit 3
*** 3
Bit 3
3210
* ; Don’t care
SCK
TMP88PS42NG
SCK
pin input/out-
pin input/