h7cx-a11d1 Omron Corporation, h7cx-a11d1 Datasheet - Page 31

• Manufacturer Part Number: h7cx-a11d1
• Description: Multifunction Preset Counter
• Manufacturer: Omron Corporation

Settings for Advanced Functions
Note: When using as a tachometer, switch to the tachometer configuration using the procedure given on page 36.
Settings that cannot be performed with the DIP switch are performed with the operation keys.
(See note 1.)
3s min.
Power ON
(See note 2.)
3s min.
Tachometer
output
mode
Counting
speed
Decimal
point
position
Prescale
value
Average
processing
Auto-zero
time
Startup
time
NPN/PNP
input mode
Display
color
Output
allocation
Key protect
level
For details on operations in run mode, refer to page 34.
The characters displayed in reverse video are the initial values.
When performing settings with operation keys only, set pin1 of the DIP switch to OFF (factory setting). If
pin 1 of the DIP switch is set to ON, the setting items indicated by
Set each setting item using the
Note: Displayed for H7CX-AU@ models
(No average
processing)
(0.1s)
(0.0s)
(HI-LO)
(0.001)
(NPN
input)
(30 Hz)
(No decimal
point)
(Red)
(KP-1)
∼
∼
∼
(99.9s)
(99.9s)
(Green)
(PNP
input)
(Average
of 2
measure-
ments)
(AREA)
(10k Hz)
(1.000)
(KP-2)
Note: 1. If the mode is switched to the function setting mode during operation, operation will
(One digit
after decimal
point)
(Red-green) (Green-red)
∼
2. Changes made to settings in function setting mode are enabled for the first time when
(HI-HI)
(99.999)
(Average
of 4
measure-
ments)
continue.
the mode is changed to run mode. Also, when settings are changed, the counter is
reset (measured values initialized and output turned OFF) on returning to run mode.
(KP-3)
keys.
(Two digits
after decimal
point)
(LO-LO)
(Average
of 8
measure-
ments)
(KP-4)
(KP-5)
(Three digits
after decimal
point)
will not be displayed.
H7CX-A
31