ATA5771_09 ATMEL [ATMEL Corporation], ATA5771_09 Datasheet - Page 233

• Manufacturer Part Number: ATA5771_09
• Description: Microcontroller with UHF ASK/FSK Transmitter
• Manufacturer: ATMEL [ATMEL Corporation]

Table 22-1.
Notes:
22.2
Figure 22-1. Maximum Frequency vs. V
180
Symbol
I
I
CC
ACLK
1. All DC Characteristics contained in this data sheet are based on actual silicon characterization of ATtiny24/44/84 AVR micro-
2. “Max” means the highest value where the pin is guaranteed to be read as low.
3. “Min” means the lowest value where the pin is guaranteed to be read as high.
4. Although each I/O port can sink more than the test conditions (10 mA at V
5. Although each I/O port can source more than the test conditions (10 mA at V
Speed Grades
ATtiny24/44/84
controllers manufactured in corner run process technology. These values are preliminary values representing design
targets, and will be updated after characterization of actual Automotive silicon.
conditions (non-transient), the following must be observed:
1] The sum of all IOL, for all ports, should not exceed 60 mA.
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test condition.
conditions (non-transient), the following must be observed:
1] The sum of all IOH, for all ports, should not exceed 60 mA.
If IOH exceeds the test condition, VOH may exceed the related specification. Pins are not guaranteed to source current
greater than the listed test condition. Pull up driving strenght of the PB3 RESET pad is weak.
Parameter
Power Supply Current
Power-down mode
Analog Comparator Input
Leakage Current
DC Characteristics
16MHz
8MHz
Active 1MHz, V
Active 4MHz, V
Active 8MHz, V
Idle 1MHz, V
Idle 4MHz, V
Idle 8MHz, V
WDT enabled, V
WDT enabled, V
WDT disabled, V
WDT disabled, V
V
V
Condition
CC
in
T
A
= V
CC
= 5V
= -40 C to 125 C, V
2.7V
CC
/2
CC
CC
CC
Safe Operating
Safe Operating
CC
CC
CC
= 3V
= 3V
= 5V
CC
CC
CC
CC
= 3V
= 3V
= 5V
= 3V
= 5V
= 3V
= 5V
Area
Area
4.5V
CC
= 2.7V to 5.5V (unless otherwise noted)
Min.
-50
5.5V
CC
CC
= 5V, 5 mA at V
0.075
= 5V, 5 mA at V
Typ.
0.4
1.8
5.0
0.3
1.2
2.5
4.3
5.0
9.0
CC
CC
= 3V) under steady state
Max.
10.0
1.5
3.0
0.2
0.5
2.5
30
50
24
36
50
= 3V) under steady state
(1)
7701C–AVR–12/08
(Continued)
Units
mA
mA
mA
mA
mA
mA
µA
µA
µA
µA
nA