DF2338VFC25V Renesas Electronics America, DF2338VFC25V Datasheet - Page 322

• Manufacturer Part Number: DF2338VFC25V
• Description: IC H8S/2300 MCU FLASH 144QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2338VFC25V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 106
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-QFP
• For Use With: EDK2329 - DEV EVALUATION KIT H8S/2329
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(b) If a DMAC transfer cycle occurs immediately after a DMAC register read cycle, the DMAC
Module Stop: When the MSTP15 bit in MSTPCR is set to 1, the DMAC clock stops, and the
module stop state is entered. However, 1 cannot be written to the MSTP15 bit if any of the DMAC
channels is enabled. This setting should therefore be made when DMAC operation is stopped.
When the DMAC clock stops, DMAC register accesses can no longer be made. Since the
following DMAC register settings are valid even in the module stop state, they should be
invalidated, if necessary, before a module stop.
• Transfer end/break interrupt (DTE = 0 and DTIE = 1)
• TEND pin enable (TEE = 1)
• DACK pin enable (FAE = 0 and SAE = 1)
Medium-Speed Mode: When the DTA bit is 0, internal interrupt signals specified as DMAC
transfer sources are edge-detected.
In medium-speed mode, the DMAC operates on a medium-speed clock, while on-chip supporting
modules operate on a high-speed clock. Consequently, if the period in which the relevant interrupt
source is cleared by the CPU, DTC, or another DMAC channel, and the next interrupt is
generated, is less than one state with respect to the DMAC clock (bus master clock), edge
detection may not be possible and the interrupt may be ignored.
Also, in medium-speed mode, DREQ pin sampling is performed on the rising edge of the medium-
speed clock.
Rev.4.00 Sep. 07, 2007 Page 290 of 1210
REJ09B0245-0400
register is read as shown in figure 7.41.
DMA internal
address
DMA register
operation
DMA control
Figure 7.41 Contention between DMAC Register Update and CPU Read
Note: The lower word of MAR is the updated value after the operation in [1].
φ
MAR upper
word read
Idle
CPU longword read
[1]
MAR lower
word read
Transfer
source
Read
[2]
DMA read
destination
DMA transfer cycle
Transfer
Write
DMA write
Idle