ST7FLITE25M6TR STMicroelectronics, ST7FLITE25M6TR Datasheet - Page 88

• Manufacturer Part Number: ST7FLITE25M6TR
• Description: IC MCU 8BIT 8K FLASH 20-SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE25M6TR

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE2x
• Core: ST7
• Data Bus Width: 8 bit
• Development Tools By Supplier: ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

Function Descriptions
Table 50. I2C_PutBuffer
Note: The above function is only for I2C Polling mode.
Caution: The application can lose control if I2C is disabled when using this function in I2C
88/235
Function Name
Function Prototype
Behaviour Description
Input Parameter 1
Input Parameter 2
Output Parameters
Required Preconditions
Functions called
Postconditions
See also
Polling mode.
* This is applicable only in multimaster I2C.
I2C_PutBuffer
I2C_TxErrCode_t I2C_PutBuffer (const unsigned char
*PtrToBuffer, unsigned char NbOfBytes)
Transmits data string in I2C Polling mode from the user
defined area. The data transmission will stop if any error
occurs during transmission. The transmission status will
be returned.
*PtrToBuffer
Start address of the user buffer.
NbOfBytes
Number of data bytes to be transmitted.
I2C_TX_AF
If Acknowledge failure has occurred.
I2C_TX_ARLO*
If Arbitration lost is detected.
I2C_TX_BERR*
If misplaced start or stop condition detected.
I2C_DATA_TX_OK
If sub-address is successfully transmitted or there is no er-
ror in data transmission.
1. I2C_Load_Address must have been called (If I2C is
configured in the master transmitter mode).
2. You must define I2C Polling mode in ST7lib_config.h.
None
None
I2C_PutBuffer (I2C Interrupt driven mode)