MC68HC908SR12CFA Freescale Semiconductor, MC68HC908SR12CFA Datasheet - Page 179

• Manufacturer Part Number: MC68HC908SR12CFA
• Description: MICROCONTROLLER 48 PIN
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC68HC908SR12CFA

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: I²C, SCI
• Peripherals: LVD, POR, PWM, Temp Sensor
• Number Of I /o: 31
• Program Memory Size: 12KB (12K x 8)
• Program Memory Type: FLASH
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 14x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: Q1145673

MC68HC908SR12•MC68HC08SR12 — Rev. 5.0
Freescale Semiconductor
NOTE:
Upon power-on reset, if the received bytes of the security code do not
match the data at locations $FFF6–$FFFD, the host fails to bypass the
security feature. The MCU remains in monitor mode, but reading a
FLASH location returns an invalid value and trying to execute code from
FLASH causes an illegal address reset. After receiving the eight security
bytes from the host, the MCU transmits a break character, signifying that
it is ready to receive a command.
The MCU does not transmit a break character until after the host sends
the eight security bits.
To determine whether the security code entered is correct, check to see
if bit 6 of RAM address $40 is set. If it is, then the correct security code
has been entered and FLASH can be accessed.
If the security sequence fails, the device should be reset by a power-on
reset and brought up in monitor mode to attempt another entry. After
failing the security sequence, the FLASH module can also be mass
erased by executing an erase routine that was downloaded into internal
RAM. The mass erase operation clears the security code locations so
that all eight security bytes become $FF (blank).
PTA0
RST
NOTES:
V
DD
1 = Echo delay, 2 bit times.
2 = Data return delay, 2 bit times.
4 = Wait 1 bit time before sending next byte.
FROM HOST
Figure 10-8. Monitor Mode Entry Timing
FROM MCU
Monitor ROM (MON)
4096 + 32 ICLK CYCLES
1
256 BUS CYCLES (MINIMUM)
4
1
1
Monitor ROM (MON)
2
4
Data Sheet
Security
1
179