GS-BT2416C1DBAT1 STMicroelectronics, GS-BT2416C1DBAT1 Datasheet - Page 10

• Manufacturer Part Number: GS-BT2416C1DBAT1
• Description: BOARD DEMO CLASS 1 W/SERIAL PORT
• Manufacturer: STMicroelectronics
• Type: Bluetoothr

Specifications of GS-BT2416C1DBAT1

• Contents: Board
• Processor Series: STLC2500
• Wireless Frequency: 2.4 GHz to 2.5 GHz
• Interface Type: RS-232, USB
• For Use With/related Products: GS-BT2416C1.A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-5793

Certifications
6.2.3
10/19
It shows an example below
Special requirement for modular application
The following requirements are fulfilled:
1.
The RF module fulfils the emission requirements of the FCC rules without additional
shielding.
2.
The module has a memory management unit inside of the IC. The processor interfacing with
the external application by means general purpose I/O (GPIO), UART, USB, PCM, I2C, SPI.
The processor interfaces also the RF part of the module exchanging data and commend
with it. Inside the processor a flash memory is available to download the customer
application and the Bluetooth
3.
The module contains an own voltage regulation. In case of changes in the supply voltage
VCC (for example caused by temperature changes or other effects), the internal voltage will
be stabilized.
4.
The RF module is for OEM (original equipment manufacturer) integration only. The end-user
product will be professionally installed in such a manner that only the authorized antenna is
used.
5.
The RF module was tested in a stand-alone configuration.
6.
The RF module will be labelled with its own FCC ID number. When the module is installed
inside the end-product, the label is not visible. The OEM manufacturer is instructed how to
apply the exterior label.
7.
The EUT is compliant with all applicable FCC rules. Detail instructions are given in the
product users guide.
8.
Contains FCC ID: S9NBT2416C1DB
The modular transmitter must have its own RF shielding:
The modular transmitter must have buffered modulation/data inputs:
The modular transmitter must have its own power supply regulation:
The modular transmitter must comply with the antenna requirements of Section 15.203
and 15.204:
The modular transmitter must be tested in a stand-alone configuration:
The modular transmitter must be labelled with its own FCC ID number:
The modular transmitter must comply with any specific rule or operating requirements
applicable to the transmitter and the manufacturer must provide adequate instructions
along with the module to explain any such requirements:
The modular transmitter must comply with any applicable RF exposure requirements.
®
profiles.
UM0471