GS-BT2416C1DBAT1 STMicroelectronics, GS-BT2416C1DBAT1 Datasheet - Page 13

• Manufacturer Part Number: GS-BT2416C1DBAT1
• Description: BOARD DEMO CLASS 1 W/SERIAL PORT
• Manufacturer: STMicroelectronics
• Type: Bluetoothr

Specifications of GS-BT2416C1DBAT1

• Contents: Board
• Processor Series: STLC2500
• Wireless Frequency: 2.4 GHz to 2.5 GHz
• Interface Type: RS-232, USB
• For Use With/related Products: GS-BT2416C1.A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-5793

UM0471
7.2
Steps to connect
(Please refer to the GS-BT2416C1.AT1 datasheet, Appendix A for the meaning of the AT
commands)
●
●
●
●
●
●
●
●
Table 4.
AT
AT+BTCMODE = 0
AT+BTPMODE = 1
AT+BTDMODE = 0
AT+BTSECMODE = 1
AT+BTENCMODE = 0
AT+BTNAME = ”SPP client”
AT+BTCLASS = 52020C
Designate a GS-BT2416C1DBAT1 board to be used as "client" and suppose it has the
address 0080E1000001. Hereafter this board will be referred to as "client"
Designate a GS-BT2416C1DBAT1 board to be used as "server" and suppose it has the
address 0080E1000002. Hereafter this board will be referred to as "server"
Connect the server board to a PC using an RS232 cable
Connect the client board to a PC using an RS232 cable
Open the hyperterminal program on both PCs and set the communication line with the
following parameters:
–
–
–
–
–
–
–
–
Power the client board with the external 5 V: on the PC screen connected to the client
should appear + READY
Power the server board with the external 5 V: on the PC screen connected to the
Server should appear + READY
Configure the client board using the following commands in
be low to select command mode - S2 switch in command mode).
Select the proper COM line (COM1, COM2……)
Baud rate: 9600 (default baud rate of GS-BT2416C1/AT module)
Data bits: 8
Parity: none
Stop bits: 1
Flow control: none
In ASCII setup, set flag line ends with line feed
In ASCII setup, set flag echo characters typed locally
Client setup
Command
ok
ok
ok
ok
ok
ok
ok
ok
Answer
Table
AT commands appendix
Check module ready
Not discoverable
Set client name
4: (GPIO3 client must
Notes
13/19