TEF6606T/V5,512 NXP Semiconductors, TEF6606T/V5,512 Datasheet - Page 26

• Manufacturer Part Number: TEF6606T/V5,512
• Description: IC TUNER CAR RADIO AM/FM 32SOIC
• Manufacturer: NXP Semiconductors

Specifications of TEF6606T/V5,512

• Modulation Or Protocol: AM, FM
• Applications: AM/FM Radio Receiver
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 8.5V
• Package / Case: 32-SOIC (0.300", 7.50mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Frequency: -
• Operating Temperature: -
• Sensitivity: -
• Memory Size: -
• Data Rate - Maximum: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 935288263512

NXP Semiconductors
LPC3152_3154
Preliminary data sheet
6.14 APB bridge
6.15 Clock Generation Unit (CGU)
The APB Bridge is a bus bridge between AMBA Advanced High-performance Bus (AHB)
and the ARM Peripheral Bus (APB) interface.
The module supports two different architectures:
The clock generation unit generates all clock signals in the system and controls the reset
signals for all modules.
The structure of the CGU is shown in
belongs to one of the domains. Each clock domain is fed by a single base clock that
originates from one of the available clock sources. Within a clock domain, fractional
dividers are available to divide the base clock to a lower frequency.
•
•
•
•
•
•
Supports all combinations of 32-bit masters and slaves (fully connected interconnect
matrix).
Round-Robin priority mechanism for bus arbitration: all masters have the same
priority and get bus access in their natural order
Four devices on a master port (listed in their natural order for bus arbitration):
– DMA
– ARM926 instruction port
– ARM926 data port
– USB OTG
Devices on a slave port (some ports are shared between multiple devices):
– AHB to APB Bridge 0
– AHB to APB Bridge 1
– AHB to APB Bridge 2
– AHB to APB Bridge 3
– AHB to APB Bridge 4
– Interrupt controller
– NAND flash controller
– MCI SD/SDIO
– USB 2.0 HS OTG
– 96 kB ISRAM0
– 96 kB ISRAM1
– 128 kB ROM
– MPMC (Multi-Purpose Memory Controller)
Single Clock Architecture, synchronous bridge. The same clock is used at the AHB
side and at the APB side of the bridge. The AHB-to-APB4 bridge uses this
architecture.
Dual Clock Architecture, asynchronous bridge. Different clocks are used at the AHB
side and at the APB side of the bridge. The AHB-to-APB0, AHB-to-APB1,
AHB-to-APB2, and AHB-to-APB3 bridges use this architecture.
All information provided in this document is subject to legal disclaimers.
Rev. 0.12 — 27 May 2010
Figure
6. Each output clock generated by the CGU
LPC3152/3154
© NXP B.V. 2010. All rights reserved.
26 of 88