LMX9830SM/NOPB National Semiconductor, LMX9830SM/NOPB Datasheet - Page 38

• Manufacturer Part Number: LMX9830SM/NOPB
• Description: IC SRL PORT MOD BLUETOOTH 60FBGA
• Manufacturer: National Semiconductor

Specifications of LMX9830SM/NOPB

• Frequency: 2.4GHz
• Data Rate - Maximum: 704kbps
• Modulation Or Protocol: Bluetooth v2.0, Class 2
• Applications: PDA's, POS Terminals
• Power - Output: 0dBm
• Sensitivity: -80dBm
• Voltage - Supply: 2.5 V ~ 3.6 V
• Current - Receiving: 65mA
• Current - Transmitting: 65mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 60-FBGA
• Physical Interfaces: UART
• Data Rate: 704Kbps
• Operating Temperature Range: -40°C To +125°C
• Msl: MSL 4 - 72 Hours
• Supply Voltage Range: 1.6V To 3.6V
• Frequency Max: 2480MHz
• Termination Type: SMD
• Rohs Compliant: Yes
• Filter Terminals: SMD
• Frequency Min: 2402MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Compliant
• Other names: *LMX9830SM; *LMX9830SM/NOPB; LMX9830SM

www.national.com
14.3 SCENARIO 3: POINT-TO-MULTIPOINT
CONNECTION
LMX9830 acts as master for several slaves.
Example: Two sensors with LMX9830; one hand-held device
with implemented LMX9830.
Serial Devices #2 and #3 establish the link automatically as
soon as they are contacted by another device. No controller
interaction is necessary for setting up the Bluetooth link. Both
switch automatically into Transparent mode. The host sends
raw data over the UART.
FIGURE 18. Automatic Point-to-Point Connection
38
Serial Device #1 is acting as master for both devices. As the
host has to decide to or from which device data is coming
from, data must be sent using the “Send data command”. If
the device receives data from the other devices, it is packaged
into an event called “Incoming data event”. The event includes
the device related port number.
If necessary, a link configuration can be stored as default in
the master Serial Device #1 to enable the automatic recon-
nect after reset, power-up, or by sending the “connect default
connection” command.
20180026