30068 Parallax Inc, 30068 Datasheet - Page 52

• Manufacturer Part Number: 30068
• Description: EMBEDDED BLUE TRANSCEIVER APPMOD
• Manufacturer: Parallax Inc

Specifications of 30068

• Frequency: 2.4GHz
• Data Rate - Maximum: 90kBaud
• Modulation Or Protocol: Bluetooth v1.1, Class 2
• Applications: Bluetooth v1.1
• Power - Output: -4dBm
• Sensitivity: -85dBm
• Voltage - Supply: 5 V ~ 10 V
• Current - Receiving: 80mA
• Current - Transmitting: 250mA
• Data Interface: PCB, Through Hole
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -20°C ~ 75°C
• Package / Case: Module
• Product: Microcontroller Accessories
• Operating Supply Voltage: 5 to 12 V
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q2239141

Establishing a Connection
Step 4:
Page 46 ▪ EmbeddedBlue 500 User Manual
6. Please note both the Outgoing and Incoming COM ports shown.
7. Click Finish.
1. Insert an eb500 module into the AppMod connector of the Board of Education
2. Connect the Board of Education board serial port to the PC.
3. Open the BASIC Stamp Editor.
4. Enter the following program code into the editor, replacing the Bluetooth device
The Microsoft Bluetooth software associates a specific COM port for a connection
from the PC to an eb500. Applications, such as HyperTerminal, use this COM port to
establish a connection and communicate with an eb500 from the PC. Remember, this
COM port is used to establish a connection from the PC to the eb500. A different
COM port is used when a connection is established from the eb500 to the PC.
This will complete the wizard and close the Add Bluetooth Device Wizard.
In this step we will attach an eb500 module to the Board of Education board and
develop a BASIC Stamp application to establish a connection with the PC.
board; assuring that Pin 1 of the eb500 module is inserted into the VSS pin of the
AppMod header.
address with the device address of the PC, which we obtained from the Hardware tab
of the Device Properties section of the Bluetooth Configuration dialog in the previous
step. This application is available in electronic form on the accompanying CD, in the
Samples folder, in the file Connect.bs2.
{$STAMP BS2}
'Wait for the eb500 radio to be ready
PAUSE 1000
'Connect to the remote device
SEROUT 1,84,[“con 00:0C:84:00:05:29”,CR]
SERIN 0,84,[WAIT(“ACK”,CR)]
'Wait for the connection to be established and switch to data mode
WaitForConnection:
HIGH 6
PAUSE 300
Write a BASIC Stamp Application to Connect to the PC
IF in5 = 0 THEN WaitForConnection