AT88RF1354-ZU Atmel, AT88RF1354-ZU Datasheet - Page 11

• Manufacturer Part Number: AT88RF1354-ZU
• Description: IC RF READER 13.56MHZ 36-VQFN
• Manufacturer: Atmel

Specifications of AT88RF1354-ZU

• Frequency: 13.56MHz
• Features: ISO14443-B
• Package / Case: 36-VQFN Exposed Pad, 36-HVQFN, 36-SQFN, 36-DHVQFN
• Pin Count: 36
• Screening Level: Industrial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Rf Type: -
• Lead Free Status / Rohs Status: Compliant

4.2.
4.2.1. ADDR [20]
4.2.2. CLKO [8]
4.2.3. ISEL [10]
4.2.4. Istat [12]
4.2.5. ResetB [9]
4.2.6. SCK [14]
4.2.7. SDI [15]
8547B–RFID–3/09
Digital Pin Descriptions
TWI device address select input pin. Selects between two TWI device addresses as shown in Table 4. In SPI
communication mode this pin should be connected to Vss.
Table 4.
Clock Out pin. The PLL register selects the frequency of the clock which is output on this pin for use by external circuits.
The default CLKO frequency is 1.978 MHz. If the clock is not needed, then the CLKO output should be disabled by
programming the ENB bit of the PLL register to one.
Table 5.
Interface Select input pin. Selects TWI communications when low. SPI communication mode 0 is selected when high.
See Appendix A and Appendix B for more details.
Interface Status output pin. Istat is the serial interface handshaking signal. A high level on Istat indicates that a byte of
data is ready to read from the serial interface port. A low level on Istat indicates that the serial interface buffer is empty.
Note:
Reset Bar input pin. A low on ResetB causes the device to reset. ResetB must be pulled high by the host
microcontroller and/or by an external resistor to V
Serial Clock input pin. In both SPI and TWI serial communication modes this pin is used as the serial interface clock.
Serial Data In pin. In SPI communication mode this pin functions as the serial data input. In TWI communication mode
this pin functions as the serial data I/O.
ADDR Pin
Bit 1
0
0
1
1
V
V
SS
CC
TWI Device Address
CLKO Output Frequency Options
Use of Istat for serial communications control is mandatory, and the AT88RF1354 will not accept
commands from the host microcontroller when Istat is high.
Bit 0
0
1
0
1
Bit 6
0
1
CLKo Frequency
1.978 MHz
3.955 MHz
7.910 MHz
15.82 MHz
Bit 5
1
1
Bit 4
13.56 MHz Type B RF Reader Specification
0
0
TWI Device Address
All other values are NOT supported
Bit 3
CC
1
1
when the device is in use.
Bit 2
0
0
Bit 1
0
1
Bit 0
0
0
TWI_R
$D5
$51
TWI_W
$D4
$50
11