025-0767-001 ITT Cannon, 025-0767-001 Datasheet - Page 102

• Manufacturer Part Number: 025-0767-001
• Description: RP CONDUCTIVE D/C 34 SHELL
• Manufacturer: ITT Cannon

Specifications of 025-0767-001

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: I025-0767-001

Wiring and Crimping Contacts
1. CONTACT INTO CRIMP TOOL
2. WIRE INTO CONTACT
3. CRIMP
4. REMOVED WIRED CONTACT FROM TOOL
Contact Insertion (DPGM/DPJM)
Contact Extraction (DPGM/DPJM
5. INSPECT
Drop contact into crimp tool, it will locate on the contact shoulder.
Take wire stripped to dimensions above, and push into the contact crimp pot until it is completely home.
Where outside diameter of wire in the #12 or COAXIAL contact is less than .096 (2.44), a rubber
bushing most be slipped over the wire before crimping (see page 103).
Squeeze the crimp tool to secure the wire into the contact. It is not possible to remove the contact from
the crimp tool until crimp is completed.
If wires are stripped and crimped correctly, the wire will be visible through the small inspection hole in
the contact.
Assembly Procedures
DPGM/DPJM/DPJMB
Wires should be stripped to the dimension
appropriate to the contact use
Extracting #20 & #16
Inserting #20 & #16
Contacts
Contacts
Extracting Coaxial & #12
Inserting Coaxial & #12
.089 DIA. MAX
(2.26)
#20 Contact
Contacts
Contacts
102
3/16 (4.76)
Contact Size
After the contacts have been crimped, they should
be threaded through the junction shell and inserted
with the tools shown below. It is recommended that
the contacts be inserted in the center horizontal
row first, then work to the top and bottom horizon-
tal rows.
If it is necessary at any time to remove contacts,
this may be accomplished with an impact extraction
tool. Simply place the correct tool on the engaging
end of the contact and push. A reversible tip is
provided for pins and sockets.
#2018
#20
#16
#12
Specifications and dimensions subject to change
Coaxial
50-75,95 &
150 ohm
Coaxial
50-75,95 &
150 ohm
Contact
Contact
#20
#16
#12
#20
#16
#12
#2018, #16 & #12 Contact
WIRE
Dimensions shown in inch (mm)
CET - 20A
Description
Description
CET - 16
CET - 12
CET - C1
CIT - 20
CIT - 16
CIT - 12
CIT - C2
1/4 (6.35)
SUPPORT OMITTED ON
Tool
Tool
www.ittcannon.com
DPJMB CONTACT
CONTACT
038894-0000
038895-0000
038896-0000
038901-0000
038889-0100
038888-0000
038890-0000
038869-0000
Assembly
Assembly
Number
Number