TSL2581CS TAOS, TSL2581CS Datasheet - Page 26

• Manufacturer Part Number: TSL2581CS
• Description: Light to Digital Converters Light to Digital 30x Sensitivity
• Manufacturer: TAOS

Specifications of TSL2581CS

• Data Bus Width: 16 bit
• Peak Wavelength: 625 nm, 850 nm
• Maximum Operating Frequency: 795 KHz
• Operating Supply Voltage: 2.7 V to 3.6 V
• Operating Current: 175 uA
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 30 C
• Interface Type: I2C
• Maximum Fall Time: 300 ns
• Maximum Rise Time: 300 ns
• Mounting Style: SMD/SMT
• Resolution: 16 bit
• Package / Case: DFN-6
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

TSL2580, TSL2581
LIGHT-TO-DIGITAL CONVERTER
TAOS098 − MARCH 2010
Power Supply Decoupling and Application Hardware Circuit
26
Copyright E 2010, TAOS Inc.
The power supply lines must be decoupled with a 0.1 μF capacitor placed as close to the device package as
possible (Figure 16). The bypass capacitor should have low effective series resistance (ESR) and low effective
series inductance (ESI), such as the common ceramic types, which provide a low impedance path to ground
at high frequencies to handle transient currents caused by internal logic switching.
Pull-up resistors (Rp) maintain the SDAH and SCLH lines at a high level when the bus is free and ensure the
signals are pulled up from a low to a high level within the required rise time. For a complete description of the
SMBus
http://www.smbus.org/specs. For a complete description of I
review the I
A pull-up resistor (R
fashion to the SCL and SDA lines. A typical impedance value between 10 kΩ and 100 kΩ can be used. Please
note that while Figure 16 shows INT being pulled up to V
maximum
2
C Specification at http://www.semiconductors.philips.com.
PI
) is also required for the interrupt (INT), which functions as a wired-AND signal in a similar
and
APPLICATION INFORMATION: HARDWARE
R
minimum
P
Figure 16. Bus Pull-Up Resistors
V
r
BUS
R
P
Rp
www.taosinc.com
R
PI
values,
TSL2580/
TSL2581
DD
V
please
DD
, the interrupt can optionally be pulled up to V
2
C maximum and minimum Rp values, please
review
SDA
r
0.1 mF
SCL
the
INT
The LUMENOLOGY r Company
SMBus
Specification
BUS
at
.