PVZ2A103C04R00 Murata, PVZ2A103C04R00 Datasheet - Page 82

• Manufacturer Part Number: PVZ2A103C04R00
• Description: Trimmer Resistors - SMD 10Kohms Open 2mm Carbon
• Manufacturer: Murata
• Type: Trimming Potentiometerr

Specifications of PVZ2A103C04R00

• Resistance: 10 KOhms
• Power Rating: 0.1 Watt (1/10 Watt)
• Operating Temperature Range: - 25 C to + 85 C
• Element Type: Carbon
• Dimensions: 2.1 mm W x 2.7 mm L x 0.8 mm H
• Product: Single-Turn Trimmer Potentiometers
• Termination Style: Solder Pad
• Tolerance: 30 %
• Number Of Turns: 1
• Taper: Linear
• Temperature Coefficient: +/- 500 PPM / C
• Product Type: Single Turn
• Adjustment: Top Crossed
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
No.
1
2
3
4
5
Rortary Position Sensors Connector Dust-proof Type (SV21) Specifications and Test Methods
Linearity
Temperature
characteristics
Rotational life
Vibration
Shock
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Item
Linearity is specified the following maximum deviation (C) as percentage of the output voltage (E) from the output voltage
approximate straight-line (Y) in FS (full scale) within the electrical effective rotational angle.
Approximate straight-line (Y=m +b) is calculated by least square from measured output voltage curve.
FS is specified the range from min. output voltage (Y min.) to max. output voltage (Y max.) of approximate straight-line within the
electrical effective rotational angle.
Temperature characteristics is specified as percentage the maximum deviation of output voltage from that at 25 2 C in FS (full
scale).
The adjustment rotor should be continuously rotated within 100 of effective electrical rotational angle, at the rate of one cycle for
1 seconds for 10 Million cycles under the condition of 25 2 C of temperature without loading.
The rotary position sensor should be tested under the condition of the amplitude of 1.5mm, the frequency range from 10 to 55Hz
(should be traversed in approximately one minute) and 2 hours in each of 3 mutually perpendicular directions (total 6 hours).
The rotary position sensor should be tested under the condition of the peak acceleration 100G max. in half-sine wave and 4
shocks in each of 3 mutually perpendicular directions (total 12 shocks).
(Linearity = C/FS x 100%)
Y= Approximate straight-line of output voltage (V)
C= Maximum deviation of output voltage (E1) from output voltage approximate straight-line (Y1)
= Rotational angle ( )
Electrical Effective Rotaitional Angle
Rotaitional Angle
Test Methods
0
Y=mX+b
E
1
(V)
Y
C
1
(V)
Y max.
FS
Y min.
R50E.pdf
81
05.9.9
9